Why are bulbs brighter in some circuits and dimmer in others?

Answer 1

Of course the answer is yes if use with our energy saving dimmer.

Our energy saving dimmer is the only one can dim CFL,LED,T4,T5,T8,ceiling lamps,halogen lamp,quartz lamp etc. in the world.

Our dimmer can apply to any brand of light source and lighting fixture.For example,our dimmer can dim the CFL of PHILIPs�ORSAM�GE etc.and this will not affect the performance and lifetime of lamp.Furthermore, dimming increases lifetime of lamp and saves energy because less electrical wattage is used. For example, a lamp that is dimmed by 25 percent uses about 20 percent less electricity and the lamp's life is increased four times.

Pls visit http: //v. blog. sohu.com/u/vw/3839082 to see the demonstration.

or send your inquiry to jennixiao [at ] @gmail.com,i would like to help you.

+++

Does dimming a light actually reduce the power consumption? Most of these use variable regulators, so where does the "lost" part of the a. c. waveform from the mains go if not into heat in the regulator itself?

Answer 2

Many dimming technologies have been used over the years, including motorized rheostats, autotransformers, magnetic amplifiers, vacuum tubes, and vats of salt water. Some of the ones that are more commercially successful are listed below.

Rheostats:

In the early 1900's, a large variable resistor called a rheostat was used to reduce the energy to the lightbulb. This resulted in high power dissipation in the 'dimmer' and no energy savings: all power was either heating the light or heating the dimmer.

Solid-state Dimmers:

Some dimmers use solid-state devices such as triacs to turn the power applied to the load on and off 120 times per second. By varying the time the power is off, the light gets brighter and dimmer. However, triac dimmers distort the sinusoidal AC waveform so cannot be used to drive motors. Triac dimmers also switch off 120 times a second while high current is flowing, creating noise (audible and electronic) and requiring filtering.

Newer solid state dimmers use IGBT devices that switch on slowly and off at zero current, reducing noise but generating more heat.

Sine wave solid state dimmers are also avaialble, that produce true sine wave output at any voltage output.

Modern dimmers using triacs are >99% efficient, however there is still some small dissipation in the triac. This causes the dimmer to become slightly warm to the touch.

Some dimmers are included in the lighting instrument, and move a mechanical shutter in front of the light source, or electronically dim the source (as with LEDs).

Answer 3

Bulbs can be brighter in some circuits due to the higher voltage across them, resulting in more current flowing through and producing more light. Conversely, bulbs can be dimmer in circuits with lower voltage or higher resistance, limiting the current and therefore the brightness of the bulb. The brightness of a bulb depends on the electrical properties of the circuit it is connected to.