Because the juju has yet to be established in the new wiring. As soon as the juju takes hold, the light brightens.
<<>>
Recheck your wiring of the switch. It sounds like you may have wired two lights in series that may have been supplied from the one switch. Two lights from one switch have to be wired in parallel with each other.
Use the discussion page if you need help with this problem
probably you have wired it wrong so look at the wiring diagram that is supplied with the dimmer switch and make sure your wiring matches................or..............................you have a energy saving bulb connected whih do not like to dim they will flicker
Some lights won't dim. If you've installed the switch properly, and are using traditional incandescent bulbs (not flourescent, LED, E-L lights or any other very low current light), the dimmer will dim the bulbs. Make sure you're using a dimmable bulb and that the dimmer is installed properly.
The lights are dimming because the starting current of the garbage disposal is causing a voltage drop, is the dimming prolonged or just for a few seconds? Do the lights come back to their full brightness or do they stay dim as long as the disposal runs? Check all electrical connections at breakers and neutral bar for over heating and tightness. Have your utility check the service and service lateral. Everything checks out find, inspect the starting capacitors in the disposal.
If the lights still won't turn on after replacing the light switch, check the circuit breaker to ensure it hasn't tripped. You can also inspect the wiring for any loose connections or faults. If these steps don't solve the issue, it may be best to consult a professional electrician to diagnose and fix the problem safely.
You probably don't need to change the dash lights. On the headlight panel there is a control to dim or brighten the dash lights. This same control allows you to turn them completely off. I don't remeber on that particular car if the light switch rotates or has a separate switch but all cars have this feature.
There should be a roll switch right next to your light switch on your dash to dim the lights with.
If the dim lights are continuously staying on there may be an issue with the dimmer switch. The actual switch may be jammed in the on position. Check the switch with a voltmeter and see if there is continuous power coming from it.
bad fuse or relay switch
First guess would be a bad switch.
To dim the lights on a 2013 Dodge Charger, locate the headlight switch on the dashboard, typically found to the left of the steering wheel. Turn the knob or slide the switch to adjust the brightness of the interior lights. For exterior headlights, ensure they are in the "Auto" or "On" position, then use the same control to adjust brightness. If you need to dim the instrument cluster lights specifically, there is often a dedicated dial near the headlight switch for that purpose.
have your battery and alternator checked but first check to see if switch for your dash lights are just turned to dim
Its the dimmer switch bad.
You can dim LED lights effectively by using a compatible dimmer switch designed for LED bulbs. Make sure the dimmer is rated for the wattage of your LED lights and follow the manufacturer's instructions for installation and usage.
If by "dim headlights" you mean low-beams... the bulbs are bad and must be replaced.
To dim the dash lights on a 2004 Honda Element, locate the dashboard light dimmer switch, which is typically found on the left side of the steering wheel, near the headlight controls. Turn the dimmer switch clockwise to brighten the lights or counterclockwise to dim them. Adjust it to your desired level of brightness. If your Element has an automatic feature, the lights may also adjust based on ambient light conditions.
On my 89 there is a ground wire on the body in front of battery. Bad connection will cause problem with headlights. Could be hi/lo dimmer switch under dash. Hard to replace without removing steering column but I unplugged switch, plugged in new switch, set new switch on dim lights, and wired new switch to steering column so I have lights but only dim lights
I would check all the wiring first. Then, you should probably figure out if any lights need to be replaced. That's my guess.