Are you sure it is the bulb that its blowing and not the Gfi tripping? Try resetting the gfi. Also try swithing to an incandescent bulb and test your gfi. Also test the cfl in a non-gfi outlet. Cfls return power they don't use and may make the gfi trip. I am not an electrician, just personal experience.
The child must have got electrocuted if the outlet switch was on. As a precaution, keep such outlet covered so that the child can not insert the finger into the outlet.
That depends upon how neatly you paint. If you get paint inside the slots, it could interfere with the electrical connection that is supposed to be made when you insert a plug. If you only paint the outside and get no paint inside, then there is no effect on the functioning of the outlet.ANOTHER OPTION:Child proof plastic outlet covers can be painted over when painting the actual outlet. When you want to use the outlet, remove the plastic cover. When the outlet plug is not in use, insert the child proof plastic covers. The plastic cover will blend right in with the outlet cover plate. It looks very nice with Hammered Spray Paint!
Read your instruction manual. If it says "Do not plug into a plug with a ground fault circuit interrupter," you are plugging it into the wrong type of outlet. Otherwise and most probably, nothing is being done wrong when the electric juicer keeps tripping the outlet. The outlet is tripping due to a ground fault. That means there is a loose wire or bad wire in the electric juicer. The ground fault keeps tripping to keep you from getting electrocuted. If the juicer is new or still under warranty, you need to take it back. If it is not under warranty, you need to get it fixed or throw it away.
Sticking a metal knife into an electric outlet is dangerous because metal conducts electricity, which can result in severe electrical shock, burns, or even death. The outlet can supply a high voltage that can cause serious injury or fatality. Additionally, it can lead to short circuits, potentially causing fires or damaging the electrical system. Always prioritize safety and keep metal objects away from outlets.
if this is a regular 110 plugin, just replace it. I suspect that you are either shorting out the wire when it is folded back into the box or the wire has been flexed too much and when folded back into the box is creating a disconnect. In either case, check the box for scorch marks, the wire for weak points or breaks in the insullation, *and* replace the receptical.
no
If it blows every time you plug in the same component, the component is bad.
If it is coming off from the lower rad. , then I would check the fitting on the rad. Maybe the ridge on the rad. outlet needs to be replaced.
Absolutely yes, there are even aftermarket dash mount scanners available.
Find out why the fuse is blowing. You have a short or the circuit is overloaded.
In one case: The charger, purchased from Radio Shack, was to blame. There is nothing wrong with the car's electrical system. This appears to be a common problem; Experienced this with several devices connected to the outlet. the fuse for the power outlets is located under the hood.
The plug may keep falling out of the outlet due to a loose fit caused by worn-out prongs on the plug or a loose outlet socket.
The child must have got electrocuted if the outlet switch was on. As a precaution, keep such outlet covered so that the child can not insert the finger into the outlet.
for fuse to keep blowing, there is a short in the eletrical system somewhere. check the a/c switch and the a/c clutch
becaz d air molecules require more space than required if u keep on blowing air into it
It has an iron base which weighs it down to keep it from blowing away in windy conditions.
not usually!!if fuse is blowing out check for short!!