answersLogoWhite

0

Check for a loose wire connection on the sides of the outlet that you plug into that causes the other two outlets to stop working. Are the screws tight? There will probably be two wires on each side, one will be the feed coming to that oulet and the other one will feed to the other outlets. Also a possible loose connection in the box that the outlet is mounted in, such as a loose or broken wire in a wire nut. Remember to shut off the power to this circuit while working on it. I hope this will help. Polarity on the third outlet could be reversed. It will blow the circuit. Is it possibly current drain i.e are there too many outlets and is the appliance something that uses a lot of current? This can be discovered by reading the manual. If lets say the junction box or fuse box had been replaced by a solid wire then this would allow more current to flow. If this wire(fuse replaced) is supplying the three outlets and a short circuit is in the appliance. The first answer is correct. The other two may be true statements, but they do not address this question.

User Avatar

Wiki User

18y ago

What else can I help you with?

Continue Learning about Natural Sciences

Does electricity flow even if nothing is plugged into the outlet?

Yes. If you hook up your phone charger, it is using a little bit over 50% power without a phone attached. No. The voltage potential of 120 volts is at the receptacle outlet slots but to make the current flow, a resistive load is needed. In the case above the phone charger is the load. Un-plug the load and no current flow.


If you unplug an appliance will it have the same effect on your electricity bill compared to turning off the breaker for that appliance?

No, unplugging an appliance completely cuts off its power supply and will not consume any electricity. Turning off the breaker only stops electricity flow to the appliance but there may still be some minimal energy loss due to standby power or other factors. Unplugging is more effective in reducing electricity consumption.


How do you test if the plug protects against electric shock?

Many GFCI plugs have a switch to test the GFCI functionality, and all you have to do it press the test button while it is plugged in. The reset button will pop out. Then you press the reset button to make the appliance operable again.If the appliance has a bulky square plug (but not a transformer), but no test nor reset switch, it is likely a single-use GFCI, meaning that once it is tripped, the appliance never works again. A lot of hairdryers are like this. The ground wire even extends to the metal screen at the end of the air duct. Some people like to put their hairdryers into their wet hair, and then they wonder why it stops working. In that case, they were saved from an electric shock. At that point, they will either need to open it up and replace the cord -- with a working GFCI cord, or replace the appliance. Most people should just get a new hairdryer at that point.Regular plugs don't protect from electrical shock. Transformer plugs don't either. Even a D-size battery has enough current to kill, but even if the transformer brings it down to even lower than that, there is always the possibility of malfunction or a power surge. In other words, don't depend on them to protect you.


Why does the breaker continue to trip until hot wire is disconnected?

There is a short somewhere in the line. Start at the outlet end and what is plugged into it and work your way back. If it is a GFI breaker, they can be bad and trip as soon as any drain is put on them. I have had them trip as soon as a drill is plugged in without even turning on the drill.


What happens when your diaphgram stops working?

If the diaphragm stops working properly, it can impair your ability to breathe efficiently. This may result in difficulty taking deep breaths, reduced oxygen intake, and increased fatigue. In severe cases, it can lead to respiratory failure and the need for mechanical ventilation.

Related Questions

What should I do if the outlet stops working?

If the outlet stops working, first try resetting the circuit breaker or replacing the fuse. If that doesn't work, check for any loose connections or damage to the outlet. If you're unsure or unable to fix it yourself, contact a qualified electrician for assistance.


Your psp x button stops working except when it is plugged in and when it is not plugged in my green on light is on even when my psp is off what can i do?

i think your psp is a bit munched!!!


Power outlet in Plymouth Voyager not working?

Sometimes things on the inside of vehicles stop working. If the power outlet in a Plymouth voyager stops working, a person should change the accessory fuse in the fuse box.


If you leave your kettle plugged into a wall receptacle does it waste electricity?

No as the circuit is broken so no electricity can flow through the ciircuit . <<>> Most small appliances these days have switches on them. The voltage potential is at the kettle but stops at the switch. As soon as the switch is turned on, the circuit is completed and the appliance operated. In the UK there is a switch combined with the receptacle. This switch is used to disconnect the voltage output to any device that is plugged into the outlet.


What should I do if my electrical outlet suddenly stopped working?

If your electrical outlet suddenly stops working, first try resetting the circuit breaker or replacing the fuse. If that doesn't work, it's best to call a licensed electrician to inspect and repair the outlet to avoid any potential hazards.


Is GE a good brand of appliance for lawn and garden equipment?

GE is a giant brand that has been around now for decades. At the very least, if your appliance stops working, you won't have to worry about the company not being around anymore to serve the warranty.


What should you do with the food when the refrigerator stops working what do you check?

Keep the fridge door and freezer door closed. This will keep food cold or frozen for at least a day or longer. First, check to see if it is plugged in. Second, check to see if it is turned on (if your fridge has a wheel or setting). While keeping the food cold, call for appliance-refrigeration repair.


What is it called when your kidney stops working?

When your kidney stops working it is called kidney failure.


If my dvd player stops working, what can i do?

First, check to see if all of your wires are plugged in this includes your power cord. Then check to see if your dvd is scratched or upside down. If these do not work try looking into problems with your television.


Why is the cord grip so important?

A cord grip stops unnecessary movement of an electrical cable. In a plug - it stops strain being put on the terminals, in an appliance - it stops the cable rubbing against the case.


Is it true or false your heart never stops working for your whole lifetime?

It is true because if your heart stops working, you can die.


What's happen when you're phone isn't working?

It stops working . .