Because after the plug is plugged in, there has to be some way of conducting the power away. That is achieved by cable or flex, using copper wires that are insulated for safety and other reasons.
The triceps brachii muscle does not flex the elbow; it is responsible for extending the elbow joint when it contracts.
The flex
The flex plate should be chosen based on the engine and transmission combination you are using. It should match the bolt pattern and size of the crankshaft and torque converter. It's best to consult the specifications of your specific engine and transmission to determine the correct flex plate to use.
A flex outlet is a wall outlet which has a flexible cable permanently wired into it instead of being fitted with a plug to go into a socket outlet. Flex outlets have their own fuse holder to replace the fuse which would normally be fitted into the plug if a fused plug were used instead. Such fused flex outlets are commonly used for electrical appliances which will never be moved, such as immersion heaters, which are permanently installed into domestic hot water storage tanks, and hot water heaters which are wall-mounted. A spur outlet is an additional wall outlet that is permanently connected to another wall outlet instead of being wired directly back to the breaker panel on its own circuit. Spur outlets are used occasionally when most socket outlets in a building are installed on a "ring main" and for some reason - usually because of cost when an additional socket outlet is found to be needed at a new point in the building - it was decided not to extend the ring main itself to that point in the building. A "ring main" is a loop of cable that goes out from a breaker to feed a "ring" of socket outlets in part of a building and then returns to be connected back to the same breaker. For instance in an average-sized house 3 ring mains would normally be installed: one for the socket outlets in the kitchen, one for the rest of the ground floor and the third for the bedroom floor. This method is used extensively in the UK and Eire where every appliance has its own correctly-fused plug.
You can flex skeletal muscles voluntary. These are the muscles you can control and move consciously. Smooth muscles and cardiac muscles, which work involuntarily, cannot be consciously flexed.
The recommended spark plug gap on a 2005 Ford Taurus 3.0 SOHC w/ Flex Fuel engine is .050" (1.27mm), according to the spark plug manufacturer DENSO.
it's generally considered to be 150 flex on "plug" race boots, although this number can be misleading since each manufacture measures flex differently. A 130 flex is used at Kenaihelski, mostly because they use ski powder.
When making a visual check of the plug and flex, I would look for any signs of damage such as frayed wires, cracks in the insulation, or discoloration. I would also ensure that the plug pins are not bent or corroded and that the connections are secure. Additionally, checking for any signs of overheating, such as melting or burn marks, is crucial. Finally, confirming that the flex is not excessively twisted or kinked would be important for safe operation.
Check plug is at back of tranny big bolt by the flex pipe.Manual says so.
take a 7mm flex socketa and a 6" extension take the bolt holding the ignition coil. and you will see the spark plug in the hole.
1955-1958. This was my father's business in Traverse City.
The regular flex is a stiffer flex than the mid flex. A regular flex is comparable to an 85 flex. The mid flex is closer to a 75 flex.
You may use the specified spark plugs as stated by the spark plug manufacturer for your make model, engine and year
Callaway make this shaft flex, it is designed in between a regular flex and stiff flex shaft.
It's on the passenger side of the oil pan. It's not on the bottom but on the side near the rear of the pan.
Flex is a DJ and Singer
.054, Although I believe the factory spec is difference if it's a flex fuel car.