Definitely not !! it would be dangerous to use 120 volt equipment on a 230 volt supply, it would either blow the fuse or blow up . .
You need a transformer to convert 230 volts to 120 volts, and you need one of the right rating. For a washing machine that might be quite a big transformer. We have 110 volt Transformers for power tools but they are not big enough.
Your 110 volt washer receptacle sounds like it is not a dedicated circuit directly fed from the distribution panel as it should be. It sounds like someone has tapped off of one side of the dryer receptacle hot and neutral terminals and run them to the receptacle for the washer. If true, this would have been done in the back side of the dryer receptacles which is located in the wall. You best get it checked out because it is likely the wire feeding the washer receptacle is a #14 rated at 15 amps and is undersized for a 30 amp breaker. A #10 wire has the capacity to be connected to a 30 amp breaker which you should find the dryer's connection to be.
The place you buy if from may do it for free, if new, or charge a small fee of $50-100.oo or less. If you hire a handy man that could vary. Both appliances come with directions how to hook up. The washer is easier than the dryer. You have a hot and cold line that connects from the washer to the spickets behind the washer, they are marked on the hoses. There is another hose that goes in the back of the washer that goes to the same spot that drains the water out on the spin cycle and a plug. On the dryer there is a plug and the vent hose that goes from the back of the dryer to the vent hole in the floor or wall. Takes less than an hour to do both. This is IF you have hook-ups already in place for a washer and dryer. If not, the costs are going to be a lot more significant. The cost depends on where you are putting the washer and dryer. If plumbing and electrical lines are close by it might run you about $400-500 for everything. (water lines to the washer, drain for the washer, electrical to the dryer and vent for dryer) However, it can be several hundred dollars more if you need to run plumbing and electrical lines significant distances (20 ft or more). To make it the cheapest possible, pick a location where water lines and an electrical box are less than 10 ft away. Also, if you do it yourself, you can save a lot of money and might only spend $100-200 in materials.
There is no advantage of every appliance having its own circuit. The modern household has many appliances and to make a separate circuit for each one would be a waste of money. This is the reason that the electrical code requires split receptacles above the kitchen counters. On the average only one or two appliances would be operating at any one given time.That said, the higher amp draw appliances have to have their own circuits. These types of appliances have an amp draw of close to what the circuit can produce. These types of circuits have breakers and wires sized to the amperage load draw of the appliance.Examples of high amperage draw appliances are clothes dryer, oven, range, hot water tank, refrigerator, freezer, microwave oven, furnace and base board heating. All of the small hand appliances can share a circuit without overloading that particular circuit.
The voltage would be the same even if you installed three washing machines. The amp draw is what will change. An automatic washer uses about 120 volts at about 700 watts, so your washer would draw a little less than six amps. It is recommended that it have a dedicated 20 amp circuit. If you install a dryer then the voltage requirement would be about 240.Rate
Don't understand this question. If the breaker is on, then the dryer would function normally, if the breaker your are referring to is the one for the dryer. If the breaker is off then no function. A dryer runs on 220.
could be fridge,stove,dryer/washer (NOT SURE)
you can't wash clothes in a dish washer because it would not clean the clothes fully, maybe it won't even clean it half way.
No, this is a washer. You would need a seperate dryer to filter the lint off of your clothes.
14
It depends on your washer and driers. If I were you I would call the company that made your appliances or call your local repairman.
Clothes will stretch to a point in the washer, so wash the clothes you shrunk. Than when they are done in the washer take them out and stretch them. Pull on the material to make it stretch and don't put it back in the dryer let them air dry.
A steam washer and dryer would be best for dry clean onl clothing.
Mud in the washer could be from dirty clothes with mud on them being washed, or due to a buildup of dirt and debris in the washing machine itself. It's important to clean out the washer's filter and tub regularly to prevent this issue.
I would go to Sears and get and HE washer. They use less power and water. Which will save you money in the long run. Plus a front loader gets your clothes cleaner ..
A washer machine may stain clothes due to excess detergent being used, clothing being overloaded in the machine, or the presence of rust or mildew in the machine. It is important to follow the manufacturer's instructions for detergent usage, avoid overloading the machine, and regularly clean the washer to prevent staining.
Its preferred to pre-wash or even do this outside with a hose if possible then i would pre-wash and then wash them with like clothes
Well since you do not want to go to the laundromat, one suggestion would be to ask a neighbor if you can use their washer and dryer. You could pay them for letting you use it.