0
What else can I help you with?
What is the cut-off mark for engineering courses in covenant university?
what is ui cutoff mark for jamb
How do you find voltage rating of zener diode?
It should be marked, either on the diode or on the box it came in. If you can't find the mark, then you have to measure it yourself. Take the zener diode, a battery or DC power supply, and a resistor. Wire them all in series, with the NEG (cathode) end of the diode closer to the POSitive side of the battery or power supply. Connect your voltmeter across the diode, and slowlyincrease the power supply output voltage while watching the meter. You'll see the voltage across the diode increase slowly, tracking the power supply, until you reach the Zener voltage. At that point, the voltage across the diode won't increase any more; it'll just stay there at its 'reverse breakdown' voltage, which is the Zener voltage. (If the voltage across the diode goes to around a volt and won't go any higher, the polarity is wrong. Reverse either the diode or else the power supply.) You probably want a wild guess at what the value of the resistor should be. That's difficult to specify if I don't know the power rating of the Zener diode you're testing. I'm going to make the following suggestion completely in the blind: Select the resistor to limit the series current to 30 mA even if you have to crank the power supply up to 50 volts. R = 50/.03 = 1.5 to 2 K-ohms, rated for a couple of watts.
How do you make a simple theodolite?
Making a simple theodolite: an activity for a measurement lessonFebruary 6, 2010Filed under tutorialsTags: 3rd grade, homeschool, math activities, measurementone responseA theodolite is a surveying instrument of unknown origin, but can be traced back to the 16th-century English mathematician Leonard Digges. This is info for you not the child.You will need:a piece of thick cardboarda plastic strawthread, or thin stringa small screwtapescissorsa rulertape measure for activityFollow these steps to make your theodolite:Cut a 6 x 6 inch square from the cardboardcut the square in half diagonallytape the straw to the diagonally cut edge of one of the trianglescut a 10″ pice of thread, and tie on end to the screwtape the other end of the thread to the triangle so that it hangs straight down along one of the 6″ edges.Your theodolite is ready to rock & roll. Not really, but is is ready to measure tall things. If you can find a straw as long as the diagonal side, then by all means allow the straw to run the entire length of the side. This was the longest straw I had.Using your new tool is simple. Follow these easy steps:find a tall object that you would like to measureraise your theodolite up to your eye, and look through the straw.find the top of your object through the strawmake sure your string with the screw on the end stays straight along the edge of your triangle.You must move backward or forward until the top of your object can be seen through the straw. The thread must stay in line with the edge of your triangle. It can not dangle forward, backward or to the side.Once you have found the correct position and can see the top of your object through the straw & the string is aligned with the edge of your triangle, mark your position on the ground. You have created an invisible triangle.After you have marked your position on the ground, measure the distance you are from the base of the object you are measuring using the tape measure.Now measure your own height.Add the distance you measured to your height. This is the height of your object.For instance, if the distance to the tree is 45 feet, and you are 4 feet 10 inches tall, your total would be 49 feet 10 inches.When we did this activity, we used a tape measure. I had her write down the distance to the object in inches, and her height in inches. After she added the 2 heights together , I had her convert the inches to feet in order to get in some math practice.So if her total were 495 inches, she would find how many feet this is by dividing by 12. It would be 41 feet, 3 inches.LikeBe the first to like this.One Response to "Making a simple theodolite: an activity for a measurement lesson"Comments Feedlessons this week-finishing up linear measure « Our Little Nature Nest [...] we walked around a bit we sat down by the river, and made a simple cardboard theodolite. A theodolite is a tool surveyors use to measure tall objects from a distance. You can make a very [...]Reply
What is the cut-off mark for engineering courses in covenant university?
what is ui cutoff mark for jamb
What engineering college for cut off mark 172 in tamilnadu?
It is not known which engineering college would be for cut off mark 172 in Tamilnadu. In the district of Coimbatore, the Hindusthan College Of Engineering And Technology has a cut off mark of 173.25.
What is the requirement for university of maidugury post ume?
candidates must score above 180 which is the cutoff mark for most courses
Last year lateral entry cutoff mark of be?
100% is the cutoff
2009 cutoff mark for anambra state university?
anambra state university cutoff mark is 170
What are the engineering colleges for the cutoff marks 182-185?
Lalith Krishnan Thuraiur In which Engg College , I will get admission with a cut off mark 189
Cutoff mark for electrical?
93%
What is the cutoff mark for clerks in corporation bank?
in tamilnadu what is the cutoff for interview selection corp bank
What is the cutoff mark of accounting in uniben?
200
The cutoff mark for midicine and surgery?
96%
What is the cutoff mark for ajasin ume?
75 52
What is the cutoff mark of kogi state university?
200
