a simple machine.
Anything with more than one simple machine in it is a compound machine. Since Wheelbarrows have both wheel-and-axle(one simple machine) and levers(Another simple machine), the wheelbarrow becomes a compound machine.
A pulley
It depends on what milling machine you are using. If its the over head type (looks like a drilling machine) or if its the type where an arbour runs horizontal to the machine - line a circular saw. IN the prior you and incline the the head of the machine to the angle you need and using the correct cutter type cun angle slots end angles etc. If your using the latter machine you would normally set the jig, vice or securing system to the angle you want and use the machine to cut the work piece. There are numourus ways to cut anglles on millers its dependant on the machine you have, cutters available, work piece securing equipment and finally the type of angle required
a cat
Lever
The wheelbarrow is a lever because it pivots about a focal point called a fulcrum, in this case located at the wheel.
A wheelbarrow is a lever and wheel and axle, so it is a compound machine.
A tool or a simple machine
2nd class lever
A fulcrum.
the wheelbarrow.
a wheelbarrow
A wheel and axle....
A wheel and axle and a lever
are simple machines shovels ,screwdriver and a hammer
The handles of a wheelbarrow would be the lever of the machine system. The wheel would be the fulcrum or center point. The part of the wheelbarrow that is used as a lever system is the operator. The operator lifts the handles and creates a lever.
Yes 2nd Answer: Actually, no it's not, because it's actually a compound machine that includes a lever and a wheel-and-axle.