answersLogoWhite

0

find the line in a dirt area first then cut the line and insert a electrical fish tape in to the line and use a metal detector to locate the sprinkler line in the concrete hope this helps Ed from denver

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you find hot water supply?

Thermal imaging is the easiest way. Also, an electronic trace can be put on the line and it can be followed under the concrete. Leaks in the line can be found other ways.


How can I repair a broken sprinkler line efficiently and effectively?

To repair a broken sprinkler line efficiently and effectively, follow these steps: Turn off the water supply to the sprinkler system. Locate the broken section of the sprinkler line. Cut out the damaged section using a pipe cutter. Insert a coupling or repair fitting to connect the two ends of the line. Secure the repair fitting in place with clamps or glue. Turn the water supply back on and check for leaks. Adjust the sprinkler heads as needed for proper coverage.


Can you raise the height of a Rainbird pop up sprinkler?

No, not without replacing the entire sprinkler (and then the hole and feeding line would have to be deeper).


Why is it important for the melting point of the solder in a fire sprinkler to be lower then its melting points of the parts it connects?

If the solder melted sooner than the surrounding parts, the line carrying the water to the sprinkler would lose pressure, resulting in the failure of the sprinkler system to deliver water.


What are the type of irrigation?

Drip Irrigation (Both on-line and in-line systems) Sprinkler Irrigation System Micro sprinklers Micro jets Rain Guns Gravity fed Drip System Semi permanent sprinkler system. Visit dripwala website for further details


How do you determine what the denominator of a fraction is?

-- First, find the line in the middle of the fraction. -- Then look under the line. The number you find down there is the denominator.


Is an oval an angle?

no it is not (unless you find the angle under a curved line)


Why is my sprinkler system making a hammering noise while the water is running while the house does not and they share the incoming water line but the sprinkler system branches off through a valve?

Obviously, the branch-off for your sprinkler system has a bowwevel or some sort of virus like that.............so.......you should get that checked out.


Why won't the sprinkler valve turn off?

The sprinkler valve may not turn off due to a malfunction in the valve itself, a problem with the wiring or control system, or a blockage in the water line. It is important to troubleshoot and address the issue promptly to prevent water waste and potential damage to the sprinkler system.


How can I install a backflow preventer for sprinkler systems?

To install a backflow preventer for sprinkler systems, follow these steps: Turn off the water supply to the sprinkler system. Locate the main water line and cut it where you want to install the preventer. Install the backflow preventer according to the manufacturer's instructions. Connect the preventer to the main water line using appropriate fittings. Turn the water supply back on and test the preventer for leaks. Ensure the preventer is properly installed and functioning correctly to prevent backflow in the sprinkler system.


Can a copper hot water line heat the concrete slab?

When installed properly and correctly, a copper line from heating system can be used to heat concrete slab.


How can I prevent pooling water around a sprinkler head?

To prevent pooling water around a sprinkler head, ensure the sprinkler head is level with the ground, adjust the spray pattern to avoid overspray, and check for any leaks or clogs in the system. Additionally, consider installing a drip line system for more targeted watering.