There should be a small ball type stud that is connected to the throttle linkage, beyond the throttle cable. The detent cable should push into that ball and stay fit there. Make sure you have the correct holding bracket for the detent cable and adjust the cable after installing if need be.
Wiki User
∙ 2006-05-24 08:50:43An HDMI cable connects from the Bell cable box to the surround receiver and then to the TV.
It screws into the transmission.
there i no cable it is controlled by the vss{vhecile speed sensor} speedomoder is controlled by the vs or vehicle speed sensor
Call your local cable company and say you would like to subscribe to there service. They will hook you up outside. It is either up to you to run cabling inside for hookup or you can have the cable provider do it for an extra fee. Run at least RG6 or RG6 quad coaxial cable inside with compression fittings only. Do not use crimp or screw on types as they tend to degrade and cause signal loss. If you are not that handy then have the cable company do it for you. Call your local cable company and say you would like to subscribe to there service. They will hook you up outside. It is either up to you to run cabling inside for hookup or you can have the cable provider do it for an extra fee. Run at least RG6 or RG6 quad coaxial cable inside with compression fittings only. Do not use crimp or screw on types as they tend to degrade and cause signal loss. If you are not that handy then have the cable company do it for you.
The GREEN and BLACK is a non stereo hook-up cable. Use the Green for VIDEO and the Black for the LEFT channel of AUDIO.
There are two excellent pdf's for this carb at summitracing.com.
There is a hook on the end of the slide hook it onto the loop inside the carb.
Connect the line to a source that is above the throttle body on the carb. It should be a source that has no vacuum at idle.
If it is like the 72 beetle, Have someone hold the the carb throttle open to give you some slack in the cable, then hook it in from the passenger side. If you hook in from the driver side it will come up done trust me
no it is impossible to hook up cable to the projector, the only way is not hook a asr cable to the DVD out box and the take rst cable from the out cable hook into the in port on the projector in conclustion you need a DVD player also
The device is called a coaxial cable.
You cannot hook up a hard drive directly to a cable box.
There is usually a line going to the distributor, and often a line going to the power brake booster. Sometimes there are other lines in use for emission control devices.
You can watch cable tv by purchasing a router from your cable company or local store. You hook the cable up to your tv and then you hook it up to your laptop.
Ethernet cable
To hook up a solenoid switch, the battery cable and the cable that goes to the starter have to be properly connected. The wire from the alternator goes to the battery cable side.
sounds like a chevy motor 250 cid. you can go original which was built by rochester, believe it or not a decent parts store could hook you up. if you want a bit more power tou can look at summit racing or jegs. holley, carter, edelbrock all make something for you motor you can even by a 4 barrel intake manifold and carb for about 50 more horse power , my suggestion by a nice holley 2 barrel carb and a carb adapter