answersLogoWhite

0

The cost to replace the head gasket is between $900 and $1200. The actual cost will vary between shops as each uses a different labor rate and there could be items that need to be repaired or replaced due to overheating that commonly occurs with a bad head gasket.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

How do you replace the head gasket located on a 1989 Mazda B2200 1.3L?

replace head gasket


Where is the fuel reset button on a 1989 Plymouth sundance?

There is no reset button for fuel. Ford has them but not Chrysler products.


Where is the crank shaft sensor on a 1989 2.5 Plymouth sundance?

This car only uses the sensor in the distributor.


Steering column replace 1989 Plymouth sundance?

To replace the steering column in a 1989 Plymouth Sundance, first, disconnect the negative battery cable to ensure safety. Remove the steering wheel, then detach the plastic cover around the column, followed by the ignition switch and any electrical connections. Unbolt the steering column from its mounting points and carefully pull it out. Install the new column by reversing the steps, ensuring all connections are secure and the steering wheel is aligned properly.


Where is the external voltage regulator located on a 1989 Plymouth Sundance?

It Doesn`t Have One. It Is Built Inside The Alternator.


How do you know which disc brake pads for 1989 Plymouth sundance?

Auto supply store (I have have good luck with mid range)


How to unplug old antenna to replace with standard antenna?

"How to unplug old antenna to replace with standard antenna on 1989 SunDance


Is it possible to replace the water pump seals on a 1989 Jeep Wrangler or do you have to replace the entire water pump?

Replace water pump and gasket


Where is the fuel filter for a 1989 Plymouth Sundance located?

Mine is located on the inboard side of the right side "beam" underneath the car just forward of the fuel tank.


How do you replace a fuel pump on a 1989 laser?

Mark and disconnect the hoses, undo the bolts and withdraw pump, spacer and gasket. Clean off old gasket and install in reverse order.


What is the name of the metal curved line that runs from the botttom of the thermostat housing around the engine for a 1989 Plymouth sundance?

Sounds like part of a heater hose. Sounds like part of a formed heater hose.


When was Plymouth Acclaim created?

Plymouth Acclaim was created in 1989.