answersLogoWhite

0

You should point it at a 40 degree angle.

User Avatar

Wiki User

15y ago

What else can I help you with?

Continue Learning about Physics

In what direction should a force be applied to produce maximum torque?

In a perpendicular direction to the rotating body.


What is the condition for maximum transfer theorem?

For maximum power transfer the load resistance should be equal to the source resistance.An often misunderstood theorem. It applies strictly where one wishes maximum power transfer.It was misused for example in early power systems by trying to match the generator resistance to the load resistance.And it has little application in audio systems, where Power is much less important than Distortion. [for least distortion, the output impedance of the amplifier should be less than 10% of the impedance of the load.]


Which one best describes the position you should be in to give maximum clearance for rear end swing?

To give maximum clearance for rear end swing, you should position your vehicle in a straight line so that the rear wheels have space to move freely without hitting anything. This is commonly referred to as the "straight line backing" position, where the vehicle is aligned straight before beginning the backing maneuver.


In young's double slit experiment the intensity of central maximum is Io what will be the intensity at the same site if one of the slits is closed?

If one of the slits is closed in Young's double-slit experiment, the intensity at the central maximum would reduce by half, from Io to Io/2. This is because when both slits are open, the waves from each slit interfere constructively at the central maximum, resulting in a maximum intensity. Closing one slit disrupts this constructive interference, leading to a reduction in intensity at the central maximum.


Why should the generator field rheostat be kept to its maximum at starting?

Keeping the generator field rheostat at its maximum at starting helps to establish a strong magnetic field in the generator, which is essential for generating sufficient voltage to initiate the generation process. This ensures a smooth and stable startup of the generator.