Which one best describes the position you should be in to give maximum clearance for rear end swing
C
A
Truck c
To lift the rock using the least amount of effort force,should push on the position farthest away from the fulcrum. This is position Z.
FIXED
You should point it at a 40 degree angle.
Why should there be a maximum? If there is friction, ALL the mechanical energy will eventually be converted to heat.
one feet .
Leaders should be concerned with power.
you should position at an angle so you can see more but if it a rotating camera the position it in the middle of what you want 2 keep under survailence
An adjustable condenser in a microscope should be set at the highest position for maximum resolution. This position allows for maximum illumination and better focus of the specimen, resulting in sharper and more detailed images.
The exhaust valves should have .005 inches of clearance, and the intake valves should have .004 inches of clearance.
refuse the clearance and request and amended clearance
On a Yamaha 1980 XS400 the valve clearance for the inlet valve should be 0.0003 inches. The valve clearance for the exhaust should be 0.006 inches.
Need to know how much clearance where.
On the 1994 Yamaha Breeze the valve clearance on the intake should be set at 0.006 inches. The valve clearance on the exhaust should be set at .011 inches.
Phase to phase clearance should be around 11.5 inches.
I believe the clearance should be within .002 and .007 thousands of an inch. and also the end play clearance, should be between .002 and .007. you should check the bearing caps with plastic gauge, and the end play wiyh a feeler gauge.
clearance volume decreases the volumetric effienfy of compressor.the clearance volume should not be too less or too more.
.002