no as the battery is made of metal and metal conducts electricity
a closed circuit is a complete circuit with no breaks at all, one example:- a closed circuit occurs when you turn the light switch on an open circuit has a physical break in the circuit, which stops the flow of electrons. one example is when the lights are turned off, the switch creates a physical break in the circuit
A break in an electric circuit is called an open circuit. Electric current will not flow through an open circuit.
The battery is the power source of the circuit. It supplies current to the circuit and the circuit is simply a path for the current to follow. When you remove the current (battery), the path still exists but there is no current going through it.
A battery or a generator.
it is necessary to connect both the terminals of a battery to a circuit for current to flow through it..!!
Yep. This is because the device needs the battery in order to work.
For it to meaningfully to be a circuit, electrons must flow round the complete circuit. Thus a source of energy is needed, be it a battery, or the mains electricity.
Yep. This is because the device needs the battery in order to work.
It is most likely a dead battery, especially if there is no power for lights or the radio. Check and clean the battery terminals because corrosion can break the electrical circuit.
Disconnecting a wire from a battery would break the circuit. If the battery was powering a bulb, the lamp would go out.
The form of potential energy inside of a battery is electrical energy travel inside the circuit. It takes cells inside the battery don't recharge, the cells are dead.
You would have a open circuit. It would appear dead.
Short circuit the connector with a 12V battery for few seconds!
A dead short occurs which can result in the battery exploding A completion in the external circuit of the battery
The purpose of the battery in a circuit is to wive energy to the circuit
Switch (mechanical or electrical), breaker or fuse.a switch
The purpose of the battery in a circuit is to wive energy to the circuit