More answers

End correction in a pipe refers to the adjustment made to account for the influence of the end effects on fluid flow. These effects occur due to the changes in fluid behavior near the open ends of the pipe, such as velocity profiles and pressure distribution. A proper end correction ensures more accurate measurements in pipe flow systems.

Q: Definition of end correction in pipe?

Write your answer...

Submit

Still have questions?

Continue Learning about Physics

End correction in a meter bridge refers to the added resistance due to the non-zero dimensions of the connecting wires or strips at the ends of the bridge. This added resistance needs to be accounted for when using the meter bridge for precise measurements. Calculating the end correction helps ensure accurate results when determining unknown resistances.

At the open end of a pipe, there is always an antinode. This is because the air particles at the open end are free to vibrate with maximum amplitude, creating a displacement node.

In a resonating pipe that is open at one end and closed at the other, standing waves are formed due to the combination of incident and reflected waves. This creates specific resonant frequencies at which the pipe vibrates strongly. The fundamental frequency for this type of pipe is when the wavelength is four times the length of the pipe.

To calculate the center of gravity of a pipe, you will need to determine the geometric center of the pipe's cross-section. This is typically done by finding the midpoint of the diameter for a circular pipe cross-section. Next, consider the material density distribution within the pipe to pinpoint the location of the center of gravity. The final center of gravity position will be a balance point where the pipe can be considered to be concentrated.

The speed of the wave in the pipe can be calculated using the formula v = f * λ, where v is the speed of the wave, f is the frequency (466.2 Hz), and λ is the wavelength which can be calculated as λ = 4L, where L is the length of the pipe (1.53 m). Therefore, the speed of the wave in the pipe is v = 466.2 Hz * 4 * 1.53 m.

Related questions

If you are asking what is the spring line of a pipe, it is the point of greatest horizontal dimension when looking at an end cross section of a pipe.

(a) 1.2r (b) 0.9r (c) 0.6r (d) 0.3r

pipe schedule is an American definition to define pipe thickness and how much pressure can the pipe stand, schedules are 10,20,40,80.., pipe schedule is nearly close to the eurobian definition for pipe class.

The significance of end correction is that it is used in the radiation acoustic impedance of a circular piston.

glass correction table

Black pipe is an amateur term for common steel or iron pipe.

A pipe that carries magma inside a volcano.

The Spigot end is the ends that goes into the socket end of the pipe

End correction occurs in measurements due to the physical dimensions of the measuring instrument or device. The end correction accounts for the fact that the measuring point is located at some distance from the end of the instrument, requiring an adjustment to ensure accurate measurements. This correction is necessary in various fields, such as acoustics, fluid mechanics, and metrology, to ensure precision in calculations and results.

A portable pipe instrument

Pipe nipple is use as connector to both pipe which have female end. It does not same as pipe reducer which nipple has same diameter throughout both end and threaded. Pipe reducer has different diameter for both end and it is use to join different pipe diameter.

Definition: Wet vent means a waste pipe that also serves as a vent pipe