answersLogoWhite

0

Yes, it is important to brake when turning to help control your speed and maintain control of the vehicle. Braking while turning can help prevent skidding or losing control of the car.

User Avatar

AnswerBot

4mo ago

What else can I help you with?

Continue Learning about Physics

Is it bad to brake while turning?

Braking while turning can cause loss of traction and control, increasing the risk of skidding or sliding. It is generally recommended to brake before entering a turn and then accelerate gently through the turn to maintain control of the vehicle.


Should you brake while turning?

Yes, it is generally recommended to brake before entering a turn rather than during the turn to maintain control and stability of the vehicle. Braking while turning can cause the vehicle to lose traction and potentially lead to a loss of control.


How does the Brake Piston Cube work?

The Brake Piston Cube is a cube-shaped tool used to retract brake caliper pistons in vehicles when changing brake pads. Its design allows it to fit into the caliper housing and apply even pressure to retract the pistons back into the caliper, facilitating easier brake pad replacement. By turning the Brake Piston Cube, the pistons are compressed uniformly without damaging the caliper or seals.


What is the ability to change the speed or direction of the vehicle?

The ability to change the speed or direction of a vehicle is controlled by the accelerator and brake pedals, as well as the steering wheel. Increasing pressure on the accelerator pedal speeds up the vehicle, while pressing the brake pedal slows it down. Turning the steering wheel changes the direction of the vehicle.


How does an aircraft brake?

When flying, by turning the power to the engines down, or pulling back on the stick. Pulling back on the stick causes the plane to gain altitude at the cost of speed. Turning the power down allows the plane to slow down due to drag. When landing, by using air brakes, by using reverse power (thrust reversers) on the engines, by using car-style brakes on the wheels.

Related Questions

When turning right and pressing the brake you have a squeek What could this be?

Probably brake pads.


Why does Parking brake light go on when turning and applying brake?

Faulty or over sensitive parking brake switch or sensor.,


Where is the brake light switch?

THE BRAKE LIGHT IS LOCATED BELOW THE DASH. LOCATE THE ARM HOLDING THE BRAKE PEDAL AND YOU WILL SEE A SWITCH THAT COMES OUT WHEN THE PEDAL IS DEPRESSED TURNING THE LIGHT ON. WHEN THE BRAKE IS RELEASED THE SWITCH DEPRESSES AGAIN TURNING THE LIGHT OFF.


1999 Geo metro brake light comes on when turning left?

low brake fluid


Brake lights not turning off?

The most probable cause is that the brake light switch is out of adjustment.


How do you repair drum brake on 1994 gmc sierra?

Brake drums can be resurfaced by turning the brake drum in a brake drum lathe. When the brake drum has deep grooves in it, it cannot be repaired.


When braking and turning what do you use?

Steering wheel and brake pedal.


Why aren't the brake lights not turning off on my Vw beetle?

Shorted wire to ground or failed brake switch.


How do you Change Brake Pads on a 2001 Nissan maxim?

tired turning the piston


How do you adjust the emergency or parking break on a 2006 Kia Spectra?

You can adjust your parking brake by turning the parking brake adjustment bolt. The parking brake adjustment bolt is located on the parking brake pad assembly.


Brake light and anti lock brake light stay on all the time unless you are turning left on a 91 pathfinder?

The brake fluid may be low. If it is low, it is a sign that you are in need of brake work soon.


Why does the parking brake light go on when turning in 1994 mercury villager?

You may be low on brake fluid. If you are low on brake fluid you may be ready for some brake work or you have a leak somewhere in the system, have it checked soon!