The function of the condenser is to condense a substance from its gaseous to its liquid state, typically by cooling it.
Liebig condenser, Vigreaux column, Snyder column, West condenser, Allihn condenser, Graham condenser, Dimroth condenser, Friedrichs condenser. There are no shortage of these!
The temperature of the water leaving the condenser would depend on the amount of heat removed from the water in the condenser. Without this information, it is not possible to accurately determine the temperature of the water leaving the condenser.
The approach temperature difference (ATD) is used to determine the condenser performance of a water-cooled condenser. It is the temperature difference between the refrigerant condensing temperature and the cooling water inlet temperature. A lower ATD indicates better performance and efficiency of the condenser.
In a total condenser te temperature is lowerd to a level on which all gasses turn to liquids. with a partial condenser you can separate gasses on there dew point. It means that the temperature is set to a level on wich a one or several gasses leave the partial condenser as a liquid and the others as a gas.
The condenser knob in a microscope is used to adjust the position of the condenser lens, controlling the amount of light that reaches the specimen. By adjusting the condenser knob, the user can optimize the illumination and contrast of the specimen being viewed under the microscope.
What are the funcation of money
Liebig condenser, Vigreaux column, Snyder column, West condenser, Allihn condenser, Graham condenser, Dimroth condenser, Friedrichs condenser. There are no shortage of these!
Which condenser are you asking about? There are a couple things that are called a condenser.
Condenser
Drain the cooling system.Remove the radiator.Recover the refrigerant.Remove the receiver dryer.Remove the condenser inlet hose bolt.Remove the condenser inlet hose.Remove the condenser outlet hose bolt.Remove the condenser outlet hose.Remove the condenser from mounts on the radiator.Remove the condenser...........................
What are the symptoms of an cooled Condenser when the air leaving the condenser is hitting a barrier and recirculating?
when the Liebig condenser was invented
The inside of the air conditioner condenser can be cleaned by removing the hoses and running water through the condenser. Run water through the condenser until the water exiting the condenser is clear.
Possible blockage in the condenser.
The Refrigerant enters the condenser as a high pressured gas, the condenser then condenses that gas and changes it to a liquid form.
Unlike a static condenser (capacitor bank), the value of reactive power from a synchronous condenser can be continuously adjusted. A synchronous condenser also has other advantages over static condensers such as: - not being affecting by harmonics (some harmonics can even be absorbed by a synch condenser) - producing no switching transients
What is the liquid that leaves the condenser called