To remove the mirror from a repeater indicator, locate the clips or screws that hold the mirror in place and carefully remove them. Once the clips or screws are undone, gently pull the mirror out of the indicator housing. Be sure to handle the mirror with care to avoid damaging it during removal.
A winker mirror, also known as a turn signal mirror, is a side mirror on a vehicle that features a built-in turn signal indicator. When the driver activates the turn signals, the mirror lights up to indicate to other drivers that the vehicle is changing lanes or turning. This helps improve visibility and safety on the road.
A mirror maker is typically called a glassworker, mirror artisan, or mirror manufacturer.
A reflection in the mirror is called a mirror image. Mirror images are the virtual images that we see when looking at our reflection in a mirror.
If you shine a mirror at another mirror, the light will bounce off the first mirror, reflect off the second mirror, and then bounce back to the first mirror. This will create an infinite loop of reflections as the light continues to bounce back and forth between the mirrors.
A plane mirror.
Fold the mirror right back against the glass and you will see a hole on the back of the mirror,if you look inside you will see a steel clip,push the clip to the left and the mirror case will slide off leaving the glass and motor behind,the rest is obvious when you see the repeater inside,this is sold as a complete unit not just the bulb
Toyota Yaris wing indicator/repeater is seal unit (it can't be opened), you have to replace the whole thing.
There are no conventional bulbs, rather there are three LEDs built into the repeater unit. Given the amount of use that they have it would be extremely unlikely for them all to fail together so if none are coming on it is more likely to be a wiring fault or similar. (check the wiring at the door hinge) To remove the unit it is necessary to prise off the painted mirror cover and remove the mirror glass by pushing in at the bottom and levering out at the top. This exposes the screws holding the repeater unit which are small torx head screws.
The indicator bulb on the VW Beetle wing mirror is an LED which means the unit must be replaced. You need to remove the mirror glass to access the LED.
http://golfgtiguides.co.uk/guides/remove-mk5-wing-mirror-and-change-indicator/ see the above site...
how do i change indicator bulb in e class wing mirror
Outside rear view mirror
To change the mirror indicator bulb on a VW Golf MK5, first find the removable panel that covers the attaching screw. Removing the screw will open the panel to give access to the bulb.
To change the mirror indicator on a Citroën Relay, first, ensure the vehicle is turned off and disconnect the battery for safety. Remove the mirror cover by gently prying it off with a flat tool, taking care not to damage the clips. Once the cover is off, disconnect the old indicator bulb or LED by twisting or pulling it out, and replace it with a new one. Finally, reassemble the mirror cover and reconnect the battery.
Press the mirror inwards at the outer edge nearest to the indicator, in the same way you would if trying to adjust the angle to see a much wider view. At the extreme end of the travel the mirror will pass inside two Philips screw heads that actually hold the indicator lens in place. Once removed the bulb can be replaced in the usual way.
I had this problem,I found it was not lamps at fault,It was a broken wire in wiring loom inside mirror (white wire)
it is a kind of active repeater that uses IF process...