0
Tension headaches can be caused by many things. Dehydration, stress, lack of sleep are some of the more common causes. It is best to see a doctor to diagnose your headaches, especially if they are prolonging.
Agnes Bogan
Wiki User
∙ 13y agoTension is a force acting on a body and it occurs when the body is in a state of work.The direction of force acts on the opposite direction of work done.
Wiki User
∙ 13y agotension is stress that stretches so that it becomes thinner in the middle
Add your answer:
Earn +20 pts
When an arch is used to support a wall over two pillars where does tension occur?
When an arch is used to support a wall over two pillars, tension does not occur.
Why does a meniscus occur?
It is because of the surface tension and cohesian of the molecules. It can be concave or convex.
What 5 forces occur in structures?
i know 5 out of six they are tension, torsion,bending, shear and centrefugal
A sentence with the word tension?
The tension between them was palpable. The room was filled with tension. Tension can be used as a noun or a verb.
Are straws stronger under tension or compression?
tension when it bends the ridges are pulling apart and thats tension
When an arch is used to support a wall over two pillars where does tension occur?
When an arch is used to support a wall over two pillars, tension does not occur.
When tension forces pull apart what occur?
Normal Fault
Why does surface tension and capillary action occur in water?
because of the gravity
Why does a meniscus occur?
It is because of the surface tension and cohesian of the molecules. It can be concave or convex.
List the three types of stress that occur in earth's crust?
the 3 kinds of stress are compression,tension, and shearing
Where does large tubercles and increased deposit of bony matrix occur?
large tubercles and/or increased deposit of bony matrix occur at sites of osteoclasts
What 5 forces occur in structures?
i know 5 out of six they are tension, torsion,bending, shear and centrefugal
What is a normal fault?
That the hanging wall is moved downward. They occur were two blocks of rock pull apart, by tension.
Where does the climax occur?
climax means the highest point of an ascent so its the point with most tension where the story leads
Locations of compression and tension in footing rebars?
Compression and tension occur in opposite side of the footing relative to position. So, at a spread ftg or pile cap, the top reinforcing will be in tension and the bottom compression. At the midspan, between spread ftgs or pile caps, the tension will occur in the bottom and compression in the top. Rebar lap splices usually occur in the compression points, so bottom lap at spread ftgs and top at midspans. Also, details will typical have additional rebar at the points of maximum tension so at the top over supports and bottom at midspans. This though should be confirmed with the Engineer of Record on any project, as assumptions can change project to project. But this is the general concept.
What is a normal geological fault?
That the hanging wall is moved downward. They occur were two blocks of rock pull apart, by tension.
Where does tension occur in objects?
Tension occurs in objects when something is pushing or pulling against something that is pulling the opposite way. Like a seagull gliding through the air or a book getting slid across carpet.
