answersLogoWhite

0

Plant load is a factor in every energy plant. In the case of solar power plants, the plant load factor is at an average of 75%. This means 25% of the time, optimum operation is not utilized. This number has to be compared with start up costs, operating costs and income generated to determine the feasibility of conversion to solar energy.

User Avatar

Wiki User

12y ago

What else can I help you with?

Continue Learning about Physics

Is a nuclear power plant and power plant the same?

A nuclear power plant is a type of power plant that generates electricity using nuclear reactions, typically involving uranium. A power plant can refer to any facility that generates electricity, including coal, natural gas, or renewable energy sources, while a nuclear power plant specifically uses nuclear energy.


What is plant factor in a power plant?

Plant Factor (The net capacity factor of a power plant ) -- To calculate the capacity factor, take the total amount of energy the plant produced during a period of time and divide by the amount of energy the plant would have produced at full capacity. Capacity factors vary greatly depending on the type of fuel that is used and the design of the plant. A base load power plant with a capacity of 1,000 megawatts (MW) might produce 648,000 megawatt-hours (MW·h) in a 30-day month. The capacity factor is 0.9 or 90%. The Burton Wold Wind Farm consists of ten Enercon E70-E4 wind turbines@ 2 MW nameplate capacity for a total installed capacity of 20 MW.[2] In 2008 the wind farm generated 43,416 MW·h of electricity. (Note 2008 was a leap year.) The capacity factor for this wind farm in 2008 was just under 25% Reasons for reduced capacity factor due to equipment failures or routine maintenance output is curtailed because the electricity is not needed or because the price of electricity is too low to make production economical. This accounts for most of the unused capacity of peaking power plants. Peaking plants may operate for only a few hours per year or up to several hours per day. Their electricity is relatively expensive. It is uneconomical, even wasteful, to make a peaking power plant as efficient as a base load plant because they do not operate enough to pay for the extra equipment cost, and perhaps not enough to offset the embodied energy of the additional components. A third reason is a variation on the second: the operators of a hydroelectric dam may uprate its nameplate capacity by adding more generator units. Since the supply of fuel (i.e. water) remains unchanged, the uprated dam obtains a higher peak output in exchange for a lower capacity factor. Because hydro plants are highly dispatchable, they are able to act as load following power plants. Having a higher peak capacity allows a dam's operators to sell more of the annual output of electricity during the hours of highest electricity demand (and thus the highest spot price). In practical terms, uprating a dam allows it tobalance a larger amount of intermittent energy sources on the grid such aswind farms and solar power plants, and to compensate for unscheduled shutdowns of baseload power plants, or brief surges in demand for electricity..... With best regards, Janybek Omorov


Can power plants do not produce electrical energy true or false?

False. Power plants are designed to produce electrical energy through various means such as burning fossil fuels, harnessing nuclear reactions, or utilizing renewable sources like wind or solar power. The primary function of a power plant is to generate electricity for homes, businesses, and industries.


Are there nuclear power plants in Hawaii?

No, there are no nuclear power plants in Hawaii. The state relies primarily on imported oil for its energy needs, along with renewable sources such as solar and wind power.


What is cpp and ipp power plant?

A CPP (Combined Power Plant) is a facility that generates both electricity and thermal energy from a single fuel source, improving overall efficiency. An IPP (Independent Power Producer) plant is a private company that generates and sells electricity to the grid, often using various energy sources such as natural gas, solar, wind, or hydro power. Both plants play a crucial role in meeting electricity demand and reducing dependence on traditional power generation methods.

Related Questions

What do solar power plants do?

the solar power plant generates electricity


What do solar plants do?

the solar power plant generates electricity


What are the solar power plants in India?

The only solar power plant that seems to exist in India is called Azure Power. However, it appears that a new power plant will be built, which will give power to 400 million citizens.


Is solar power plant is better than wind power plant?

Yes, solar power plants are better than wind power plants. The reason is that wind power plants convert wind into electricity, but if there is no wind, wind power plants won't be able to do their job. Solar Power Plants use solar energy from our entire solar system. There is infinite solar energy in the solar system, so solar solar power plants are better. Solar and wind do not produce any real power in terms of our needs. Solar is the worst of the two by a small margin. Typical payback, in terms of energy used to create and maintain a solar panel is longer then the projected life of a panel. Winds worst issue is the needed fossil fuel plants running in the background. This power is completely wasted unless the wind stops or slows below the running speed of the turbine. Wind also stops generating power at speeds above 32 mph. The fossil fuel plant again will make up this loss. The better alternative is hydro then either of these that provide little or no power.


When did the operation of the largest solar power plant in the Philippines start?

The solar photovoltaic power plant of the Cagayan Electric Power and Light Company, Inc. (CEPALCO), is not only the largest solar power plant in the Philippines, but in the entire Southeast Asia. CEPALCO started operating the plant last July 2004.


What is the salary for people working in solar power plants?

in solar power


Plf related to solar?

Yes, Plant Load Factor (PLF) is related to solar.


What kind of jobs are available in the solar energy industry?

There are many different jobs available in the solar energy industry. Anything from scientific research, to solar power engineering, to manufacturing the solar power, working at a solar power plant, development of the plant, construction of the plant, plant operations, solar photovolataic installers, panel installation and maintenance and supporting occupations.


What is the most common type of power plant?

The most common type of power plant is one that uses fossil fuels such as coal, oil or natural gas. Less common power plants use nuclear, geo-thermal, hydro-electric, wind, solar, or other power sources to run the plants.


How many power plants use solar energy?

There are two types of solar energy plants: 1. Plants that use sun's rays directly to heat a medium (sometimes a hybrid plant with natural gas). See Wikipedia entry 'List of Solar Thermal Power Stations' 2. Plants that use photovoltaic cells to produce electricity. See Wikipedia entry 'Photovoltaic Power Stations' Both these articles list plants in various countries including the US


Why are there more coal power plants then solar power plants?

There are more coal plants than solar plants because the cost per Mega-Watt is much less using coal than solar power, and currently coal is more efficient. The problem today is that in a environmentally conscious society coal is a 'dirty' fuel, and solar power is clean. That is why environmentalists are pushing for more Solar (and wind) power generation.


How does solar power effect the earth?

All weather phenomena hydro-electric plants all plant life and dependent animal life.