When geyser is connected there is a substantial increase in the line current. So the drop due to line resistance increases(line current * line resistance). Because of this available voltage for the bulb comes down(Vline - line drop). So it becomes dimmer. It is not becoming dimmer for a moment but continously it will be dim. May be your eyes are not able to sense it. If you watch carefully it can be seen. But when a large motor is switched on what you have told happens. Because motor draws more current for starting.
The geyser obviously draws a very large start-up current, which causes voltage drop in the local area, i.e. your house.
something
As light moves through the air, it slowly diminishes, until it finally disappears. When light bounces of any object, light turns to colour. Objects become dimmer because the further back it moves, the more coloured light diminishes, causing the object to look dimmer in light and colour.
As light moves through the air, it slowly diminishes, until it finally disappears. When light bounces of any object, light turns to colour. Objects become dimmer because the further back it moves, the more coloured light diminishes, causing the object to look dimmer in light and colour.
Lower levels of light are what causes the dimmer switch to heat up. The extra electricity that is not being used when the light is lowered is sent to the circuitry of the dimmer switch. The heating up is normal.
Because some of it was absorbed so then it Becomes dimmer
Well it is only a guess but I would say your bathroom and bedroom were sharing the same cct and you have not kept the cct going by placing the dimmer in line. There would be a continuation of wiring from the dimmer to the bathroom that you have perhaps not reconnected.
You will find a loose electrical connection where the spark is occuring.
That's one I've never seen. Does the bathroom light turn ON when the bedroom light is switched Off? Does the bathroom light switch turn the bathroom light on and off normally when the bedroom light switch is left on? Need to answer these questions, then find where the bathroom light power comes from. It's power supply should either go directly from the power oanel to the bathroom light or to the bathroom light switch. The bathroom light switch merely acts as an interrupter for the hot leg of this power supply.
This may sound like a stupid thing, but turn up the dash light dimmer, they will be bright while the headlih[ghts are off because its supposed to be daytime, but once the lights are switched on nighttime rules take over and the dimmer controls the lights intensity.
A dimmer switch is very helpful as if you attach one to your light switch you can control your light intensity, the Lutron Dimmer is a brand dimmer switches that provide high quality performance.
something
Dimmer switches go bad, more often than regular switches.
Regular Dimmer will work.
Dim lights are almost always a bad ground connection on the dim light, just loosen and retighten the ground wire to restore the connection.
when a light bulb is switched on it will blown..............
The headlight high/low beam dimmer switch is part of the turn signal switch.The dash light dimmer is next to the headlight on/off switch.The headlight high/low beam dimmer switch is part of the turn signal switch.The dash light dimmer is next to the headlight on/off switch.
A beam of light becoming dimmer is a physical change since it is reversible. Recharging its source will make the light beam bright again.