0
What else can I help you with?
Why it is easier to lift the same load by using three -pulley system than two-pulley system?
A three-pulley system allows the load to be distributed among three supporting strands, making it easier to lift the load as each strand bears less weight compared to a two-pulley system where the load is evenly distributed between only two strands. The mechanical advantage of the three-pulley system reduces the amount of force required to lift the load, making it easier to lift.
What two parts make up a pulley?
A pulley typically consists of two main parts: a wheel with a groove for a rope or belt to run along, and a shaft that supports the wheel and allows it to rotate. The wheel can either be fixed in place or able to move.
What forces act on a pulley?
The forces acting on a pulley are tension forces exerted by the ropes or cables pulling on it. These tension forces cause the pulley to rotate and transfer motion and forces between different parts of a system. Frictional forces may also act on the pulley, depending on the surface it is in contact with.
What are the three kinds of pulley?
The three types of pulleys are fixed pulley, movable pulley, and compound pulley. Fixed pulleys are attached to a stationary object, movable pulleys move along with the load, and compound pulleys combine both fixed and movable pulleys to provide mechanical advantage.
How much faster will 3 pulley with a belt and one of them is a small pulley will spin?
When using three pulleys with a belt where one of them is a small pulley, the small pulley will spin faster compared to the others. This is due to the principle of rotational speed being inversely proportional to the radius of the pulley. The small pulley has a smaller radius, so it will rotate faster than the larger pulleys in the system.
What are all the parts of a pulley?
a pulley is a wheel with a groove along with a rope or chain.
What are three types of pulleys?
Fixed pulley, Movable pulley, block and tackle
Power steering pump pulley?
It takes a special tool to remove the pulley and install the pulley. The tool can be rented from your local auto parts store.
How do you remove power steering pulley 2005 impala?
To remove that pulley with out damaging the pump or the pulley you need a power steering pulley puller. This tool will also install the pulley. Your local auto parts store can rent or sell you that puller.
Ac bypass pulley on 1989 Chevy?
An ac bypass pulley for a 1989 Chevrolet can be purchased at any auto parts store. The cost for the pulley starts at $26.04.
How does the power steering pulley come off a ford ranger?
The pulley needs to be removed before you can extract the pump, you can get the pulley removal tool at a car parts store.
How do you change a bad bearing in a pulley?
In most cases you can purchase the bearing and pulley as an assembly from your local auto parts store.
How do you get the power steering pulley off a 1999 suburban?
It requires a power steering pulley PULLER. You can rent them at some parts stores.
What parts might make a pulley?
A wheel, a groove and a rope/chain.
Which of the following is not a compound machine pulley bicycle?
The bicycle is not a simple machine, there are too many interacting moving parts.
How do you remove the power steering pulley from a 1996 Pontiac Bonneville?
There is a specific tool for this operation. It is a power steering pump pulley puller. This grabs the groove in the end of the pulley and pushes the punp shaft away from the pulley. Available at your parts store.
What is a idle pulley?
idle pulley is a pulley on an engine that does not drive any accesories ,such as water pump or alternator. it is put there to route the belt so as the belt will not hit or rub on other parts or accesories
