A degaussing coil is a device used to remove a residual magnetic field, usually from a Cathode Ray Tube (CRT).
One way you can write it is : She had to coil it around to activate it.Or you could say: I had to coil it for a project.
When the magnet is withdrawn from the coil, the magnetic field within the coil will decrease, inducing a voltage in the coil. This induced voltage will create a current in the coil that flows in such a way as to try to maintain the original magnetic field.
Moving into a coil with more loops increases the magnetic flux linked with the coil, resulting in a higher induced electromotive force (emf) in the coil. This leads to a stronger current being induced in the coil due to Faraday's law of electromagnetic induction.
The magnetic field in a moving coil galvanometer is made radial by surrounding the coil with a cylindrical magnetic core. When current flows through the coil, it creates a magnetic field perpendicular to the coil. This magnetic field interacts with the radial magnetic field of the core, causing a torque on the coil that deflects the pointer.
When a magnet is pushed in and out of a coil, it creates a changing magnetic field in the coil. This changing magnetic field induces an electromotive force (EMF) in the coil, which causes current to flow through the coil according to Faraday's law of electromagnetic induction. The amount of current flow is proportional to the rate of change of the magnetic field.
A no volt coil is a type of electrical coil that is designed to prevent a machine from automatically restarting after a power interruption. It keeps the machine in a safe state until an operator initiates a restart, reducing the risk of accidents or damage.
Coil clearing contacts are used in electrical relay systems to ensure that the relay coil is de-energized and to facilitate the proper operation of the relay. When the relay coil is energized, these contacts help clear any residual current or voltage from the coil, preventing unintended activation or malfunction. This is crucial for the reliable operation of the relay, especially in applications requiring precise control and safety. Ultimately, coil clearing contacts enhance the overall performance and longevity of relay systems.
Lacuna coil
The coil is inside the distributor. There is no coil wire.The coil is inside the distributor. There is no coil wire.
These terms apply to the coils inside a wattmeter. 'Pressure coil' is an archaic term for 'voltage coil', which is connected in parallel with the supply, while the 'current coil' is connected in series with the load.
The coil wire runs from the coil to the center of the distributor cap.The coil wire runs from the coil to the center of the distributor cap.
Did coil
The indoor coil acts as an evaporator coil for heating.
coil
Low on refrigerant or there is not enough flow across the evaporator (cold coil). Check fan and make sure inside coil is clean. The line might frost slightly at times de pending on the cooler temperature.
if the coil is on the distributor cap,remove cover then disconnect wires from the coil and remove coil. if coil is on engine then loosen the bolt and remove from coil mount
The coil is inside. Check to see if the filter is dirty as well. To clean the coil you must remove the front panel to the evap coil. If you have a flat coil you must slide the coil out to clean it. If you have an A coil, take off the plate on the front of the coil and you should be able to visually inspect the coil. It is important that you do not mash the dirt into the coil fins.