0
What else can I help you with?
What is loading rate in atomic force microscopy?
The loading rate represents the changing in applied force with time.loading rate =dF/dt.It is a generalterm used not only for AFM but also for Dynamic Force Spectroscopy(DFS).loading rate = ksvv= velocity, ks=spring constant.Best wishes
How the bulking affects for BOD removal efficiency?
Bulking in a wastewater treatment system can reduce the removal efficiency of biological oxygen demand (BOD) as it can lead to poor settling of biomass and reduced contact between bacteria and organic matter. This can result in a decrease in the effectiveness of the biological processes responsible for BOD removal. Managing and controlling bulking through proper operation and maintenance practices is essential to maintain high BOD removal efficiency in wastewater treatment systems.
What are the advantages of a front-loading washer compared to a top-loading washer?
Front-loading washers typically use less water, energy, and detergent compared to top-loading washers. They also tend to be more gentle on clothes due to the tumbling motion of the drum. Additionally, front-loading washers can generally accommodate larger laundry loads.
What is the difference between direct loading and phantom loading?
Phantom loading consits of supplying the pressure circuit from a seperate low voltage supply. It s possible to circulate rated current through the curent circuit with a low voltage supply as the impedance of this is very low. therfore the total power required for testing the meter is compartively smal with phantom loading.
In which factor does breaking stress depends?
Breaking stress of a material depends on factors such as the material's type, structure, temperature, and loading rate. It measures the maximum stress a material can withstand before breaking.
What is organic loading rate?
Organic loading rate (OLR) is a measure of the amount of organic matter being fed into a biological treatment system per unit of time. It is typically expressed in terms of chemical oxygen demand (COD) or biochemical oxygen demand (BOD) per unit volume of the system. OLR is an important parameter in designing and operating biological treatment systems such as anaerobic digesters or activated sludge systems.
Discuss what is meant by forward loading and backward loading?
pre planned discussions
What is loading rate in atomic force microscopy?
The loading rate represents the changing in applied force with time.loading rate =dF/dt.It is a generalterm used not only for AFM but also for Dynamic Force Spectroscopy(DFS).loading rate = ksvv= velocity, ks=spring constant.Best wishes
What is BOD and COD of spent wash?
COD=100 What is Bod
When was Bod - series - created?
Bod - series - was created in 1975.
When did Bod - series - end?
Bod - series - ended in 1984.
Point c is in the of BOD?
Adjacent Angle
What did bod plan to do with the card that held jacks name?
bod threw it
Who is Christian Yuzicapi-bod?
He is christian yuziacapi bod> he likes boys
What is meant by discount rate?
cheaper than standard rate :)
What is loading rate?
The maximum amperage draw or load that the device or wire can safely carry.
When was Van Bod born?
Van Bod was born on 1978-03-22.
