Response time of the sensor.For 1 sec how many times you can sense the object.
Natural frequency in physics refers to the frequency at which an object naturally vibrates or oscillates when disturbed. It is determined by the object's physical properties, such as mass and stiffness.
When the product of frequency and time period is equal to 1, it indicates that the oscillation completes one full cycle in one second, which is the definition of the unit hertz (Hz) for frequency.
An oscilloscope is the machine, but it measures frequency.... so sound waves are measured by frequency
The phrase "the number of waves passing a point each second" is a definition of frequency.So if that number increases, then the frequency increases, by definition.
Wave velocity is the speed at which a wave travels through a medium. It is determined by the frequency and wavelength of the wave, following the equation velocity = frequency x wavelength.
switching frequency is the one which regulates the switching device in a electronic circuit,by which the output voltage can be determined or can be cntrolled
FET's improve the switching frequency from KHZ to MHZ.. FET can be used as temperature sensor.. and mosfet is used as a switch..
Switching action is an electrical component that can break. This is the meaning in electrical engineering.
The definition of fundamental frequency is the lowest frequency of a periodic waveform. Sometimes fundamental frequency is abbreviated by FF, containing the lowest frequency starting from 0.
What is the problem? Transistors can easily switch about any electrical or radio frequency needing switching today.
Multiplexing-Combining all the inputs into one output. Switching-Taking one input to the output, at a time/frequency
02 Sensor Insufficient Switching Bank 1 Sensor 1
Diodes have capacitance, placing a limit on their switching rate.
HO2S Insufficient Switching Sensor 1
A HEGO sensor indicating lean at the end of a test is trying to correct for an over-rich condition. The test fails when the fuel control system no longer detects switching for a calibrated amount of time.
This term is often used with electronics and engineering. By definition, the recovery time of a sensor is the time a sensor takes to return to a baseline value after an event.
It is a switching regulator.