answersLogoWhite

0

on most cars with a lever next to the windscreen wipers, it's usually cruise control or a speed limiter

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

What size socket to remove rear brake drum on peugoet 206?

30/32 mm


Peugoet 206 will turn over but will not start?

Its either the battery or starter motor. Have you tried to jump start it?


Where is the windscreen wiper fuse located in a peugeot 206?

If the windscreen wiper is electric or controlled by a switch, it has a fuse. The wiper fuse on a Peugeot 206 is located in the fuse box in the engine compartment.


How many miles before a timing belt change on peugoet 206 sw?

Change it every 60,000 miles.


How do you reset airbag light on dashboard on a peugoet 206?

Have the air bag system repaired and the light will reset itself.


Peugoet 206 ignition relay click when engine switched off?

This is normal in 2002 and later models because of the electronic control box.


Which fuse in engine box do you test for radiator fan in a peugoet 206?

hi chances are that it wont be a fuse but your coolant temprarure sensor swith hope this helps ?


Where is the fuse for the front wiper on a peugeot 206?

fuse 17 eng compartment 30A


Why would the front windscreen wiper relay on your peugeot 206 have stopped working is this easy to replace and how much would it cost?

front wiper relay


How do you remove rear wiper arm from peugeot 206 sw?

Remove the wiper arm retaining clip. The retaining clip will be just below the wiper arm connection. Hold the retaining clip in and the wiper arm will come off.


Where is the lever for the bonnet of a peugeot 206 sw?

left hand side under the glovebox


How do you change a indicator stalk on a peugeot 206 with a air bag?

i had the same problem,What you need to do is remove the housing around the steering wheel,light and wiper lever. Remove the two screws and the electrical connector on the block at the end of the lever,Then open the block and clean the steel tracks (They are shorted with metal filings from the steel pin that connects them). Re-assemble and you are good to go,Good luck