0
What else can I help you with?
What is the top bit of a wind mill called?
The top bit of a windmill is called the rotor or the turbine. It is the part that captures the wind and converts it into rotational energy to generate electricity.
What is the top of a wavelength called?
The top of a wavelength is called the crest.
What is the top bit of a pencil made out of?
The top bit of a pencil, also known as the eraser, is typically made out of rubber or synthetic materials designed to remove pencil marks by friction.
What is the top of a shoe called?
The top part of a shoe is called the upper
What is the top part and bottom part of a wave called?
The top part of a wave is called the crest, while the bottom part is called the trough.
What is the name of the thing that sticks off of the top of a caboose?
That is called a cupola.
What is the end of a battery called?
The top of a battery is called a carbon rod, which is on the positive terminal.
What is the top bit of a fraction called?
Numerator
What is the top bit of the ear called?
helix
What is the top bit of a wind mill called?
The top bit of a windmill is called the rotor or the turbine. It is the part that captures the wind and converts it into rotational energy to generate electricity.
What is the state called in the center of Australia?
The top bit of the centre is called the Northern Territory, the bottom bit is South Australia.
What is the fingerboard on violin?
The top bit, called a fret board on a guitar
What is an arch on a beach?
It is were the sea erodes right through the land leaving a bit on each side and a curved bit at the top but sometimes the top bit falls into the sea and then the bits that are left are called a stack.
How can I fix a door that sticks at the top?
To fix a door that sticks at the top, you can try tightening the screws on the hinges, sanding down the top edge of the door, or adjusting the door frame.
What is the fan like bit of hair at the top of a pony's tail called?
ice tail
Where can you go to get DX glow sticks?
You get them in Early Poptropica island, then you go right, then you go down the well and you jump to the top left ledge! Hope I helped you a bit!
What is the proper way to put acid in a new motorcycle battery?
Get a flashlight and look into the fill holes in the top of the battery. See those plates in there? Slowly add acid to each fill chamber until the acid barely covers the top of the plates. Go do something else for 5 minutes, and recheck the acid level. You will find it dropped a bit. Add more acid until the plates are barely covered. Put your fill caps on and place the battery on a battery charger. After this, you top the battery up to the top of the plates with DISTILLED WATER ONLY. There you go. Done.
