To keep the pressure equalized. If you have a pen with no hole, and were to take it up in an airplane, or even to the top of a building, the pressure difference could cause the ink to flow out of the pen creating a mess and making writing really messy.
There is a hole in the body of the Compressed polystyrene to equalise atmospheric pressure, for the reasons stated above, however the hole in the top of the lid is to prevent children for sucking the lid into their throat, subsequently this provides an air passage in such a case.
The tip of the pen is the top because that's where you would put the pen cap
The opposite end to where the pen would write
The hole is for equalizing air pressure that allows the ink to flow smoothly. Without the hole, a vacuum can form inside the pen, preventing ink from being dispensed properly.
The small hole in the main body of a ballpoint pen is known as a pressure-equalizing vent. It helps regulate the air pressure inside the pen, preventing leaks and ensuring smooth ink flow.
If it was completely airtight, then the pressure inside would drop, preventing ink flow. Placing a hole in the middle equalises the pressure and controls the flow of ink. The hole, basically, stops the pen from leaking ink.
to stop the ink from drying up
plastic
Zero, pen lids don't kill anyone. Ha, take that, Ollie!
The rubber circles around the top of cup lids are buttons to mark what type of drink it is such as diet and other.
The tip of the pen is the top because that's where you would put the pen cap
you can put them in jars with lids only if you put holes on the top which you can drill in i hope i was a good help
if you are refering to the lids that you see on the streets its that the lid will not fall into the hole, also most piping is circular
I would think that it would be called the pen cap or the cap of a pen. Top of the pen or pen top may also be used. But I don't really believe that the lid of a pen is the correct use of the word "lid" in the phrase.
The opposite end to where the pen would write
if you are refering to the lids that you see on the streets its that the lid will not fall into the hole, also most piping is circular
Where is Vole Hole 2?Vole hole 2 is in appleton, below the " rent a horse " pen.
The hole is for equalizing air pressure that allows the ink to flow smoothly. Without the hole, a vacuum can form inside the pen, preventing ink from being dispensed properly.