0
Can someone please help me!!! once i switch it of it floats back to the bottom and i don't know why?
The wax and liquid are different densities. Density changes with temperature. When the wax is near the heat source, its temperature increases and it becomes less dense compared to the liquid and then it floats to the top. When it gets to the top, it cools down because it is farther from the heat source. When it cools down, it becomes denser than the liquid, and it sinks. So when you turn off the lava lamp, the wax and liquid cool to room temperature, and the wax is denser than the liquid so it stays at the bottom.
What else can I help you with?
How long does it take for your fingers to wrinkle in water?
It typically takes about 5 minutes for your fingers to start wrinkling in water. This process is known as "wrinkling due to water immersion," and is caused by the outer layer of skin absorbing water and expanding, while the inner layers stay the same size.
Why does an electric bulb not become dim when another bulb of the same power in a parallel circuit is switched on?
In a parallel circuit, each bulb gets the full voltage supply independently. Therefore, adding another bulb does not affect the voltage across the original bulb, keeping its brightness unchanged. Both bulbs receive the same voltage as they would if they were the only bulb in the circuit.
How does a kestrel hover in the air while hunting for prey?
A kestrel hovers in the air while hunting for prey by using its wings to make quick adjustments to stay in one spot. It also uses its tail to help balance and steer. This allows the kestrel to stay in one place and scan the ground for potential prey.
How long can you safely stay in a sauna without risking harm or death?
It is generally safe to stay in a sauna for about 15-20 minutes at a time to avoid the risk of harm or overheating. It is important to listen to your body and leave the sauna if you start feeling dizzy, lightheaded, or uncomfortable.
Which term refers to the tendency of an object to maintain its state of motion?
Inertia. An object at rest, tends to stay at rest, while an object in motion tends to stay in motion.
Can a lava lamp be fixed when the lava has been shaken?
well the whole point of a lava lamp is to watch the lava go up and down in the fluid. once it is shaken though, normally the "lava" becomes separated into smaller pieces. it will stay that way.
What will you do if a volcano erupt?
Take a Metal that can hold the Heat of the Lava and stay behind it until the lava stops.
How do you reset replaced ecm to key?
Attempt to start the engine, it will probably fire then stop, with the security lamp on. Do not turn the switch off, let it stay on till the lamp goes out, (about 10 min) then attempt to start again. Once again it will fire then stop with the security lamp on. When you have went thru this procedure three or four times, and the new key code is learned, the engine will run.
A sentence for lava?
Let's try to stay far away from that hot lava. The lava is flowing very quickly.
Why do headlights stay on 1998 Mercury Sable?
Replace auto lamp module.
How long do baby quails stay under a heat lamp for?
Six weeks
Why does pole star appears to be stationary while earth rotates?
Imagine you are riding on a roundabout, with a lamp post in the middle of it. As you are riding you look upwards at the lamp, and it always seems to stay in the same place as everything else goes round you. In normal life the Earth is our roundabout and the Pole star is the lamp. It is called the pole star because it is in line with the Earth's north and south poles, on a line that we can call the lamp-post.
How long does the lava stay hot for?
It usually depends on how hot the lava and how cold the water is. I think it can take around half a minute for the lava to cool off when its in cold water and that's all i can think of.
Can using a tanning lamp damage your skin?
Yes, it is. Any sunlight, even artificial, can cause skin damage, and lead to cancer. Always use sunscreen while out in the sun, and stay away from tanning lamps.
How long does the heat lamp have to stay on for a gecko?
Leopard geckos should be on a 12 hour light cycle.
How much time does a baby pitbull have to stay with its mother?
All puppies must stay with their mothers for at least 8 weeks, until their eyes open, and they start crawling or walking. They must also stay with their mothers while they are nursing. after 6 or 7 weeks you can start feeding the puppy soft dog food.
Why would a 92 Cavalier start when it is cold but not stay running after a while?
mine did that and i replaced the crank shaft sensor,problem was fixed
