answersLogoWhite

0

To tip a Briggs and Stratton mower safely, make sure the air filter and oil cap are secure, and tilt it with the carburetor side up to prevent oil leaks. Avoid tipping it too far or for too long to prevent engine damage.

User Avatar

AnswerBot

4mo ago

What else can I help you with?

Related Questions

What point gap model 221432 Briggs and stratton?

A piece of a cigarette box should do it .


When does a Briggs and Stratton ignite in the cylinder cycle. Should the cylinder be at the top of compression?

No. It should be just past top.


What is the horse power of a Briggs and stratton model 143302?

that should be 6 horse it is 14 cid


What kind of oil does a 3.5 hp Briggs and stratton lawn mower take?

Briggs and stratton engines use different oils depending on the temperature to which the engines will be used. Generally sae30 oil should be used for mower engines


What is the spark plug gap for a Briggs and Stratton 13 hp engine?

The spark plug gap for a Briggs and Stratton 13 horsepower engine should be .030 inches. A spark plug for this engine may be purchased at an auto parts store.


How much oil does a Briggs and stratton 5.5 horse power lawn mower motor take?

You should always have 20 fluid ounces of oil in a Briggs and Stratton 5.5 HP lawn mower. This equals out to roughly 1.6 quarts.


What is the gas oil ratio for a 3.5 hp Murray lawn mower powered by Briggs n stratton?

There is no "gas oil ratio", the 3.5 hp Briggs and Stratton engine is a four-stroke design, oil should NOT be put into the fuel!!!


What is the spark plug gap for a Briggs and stratton 4.5 hp engine?

The spark plug gap for a Briggs and Stratton 13 horsepower engine should be .030 inches. A spark plug for this engine may be purchased at an auto parts store.


How do you check a Briggs and stratton regulator?

To check a Briggs and Stratton regulator, first ensure the engine is off and the battery is disconnected for safety. Then, inspect the regulator for any visible damage or corrosion. Use a multimeter to measure the output voltage; it should typically be around 13.5 to 14.5 volts when the engine is running. If the output is outside this range or inconsistent, the regulator may need replacement.


Should you replace condenser and points on a 6hp Briggs Stratton engine?

If they are bad, then yes. If not, then don't bother replacing them.


What champion spark plug does a 12.5 hp Briggs and stratton engine take?

Should take a Champion: RC12YC


What is the correct spark gap for a Briggs and stratton 5hp lawnmower?

The spark plug should be gaped at .030"(76mm)