Your Honda GCV170 pull cord may be stuck due to a variety of reasons, such as a tangled cord, a dirty recoil mechanism, or a malfunctioning engine. To fix it, you can try untangling the cord, cleaning the recoil mechanism, or checking the engine for any issues. If these steps don't work, it may be best to consult a professional mechanic for further assistance.
Your Honda lawnmower's pull cord may be stuck due to a few reasons, such as a tangled cord, a dirty recoil starter, or a worn-out recoil spring. To fix it, you can try untangling the cord, cleaning the recoil starter, or replacing the recoil spring if necessary.
Your Honda mower's pull cord may be stuck due to a variety of reasons such as a tangled cord, a dirty recoil starter, or a malfunctioning engine. To fix it, you can try untangling the cord, cleaning the recoil starter, or checking the engine for any issues. If these steps don't work, it may be best to consult a professional for further assistance.
The cord on your Honda lawn mower may not pull if it is tangled, the engine is seized, or the recoil starter is broken.
One reason that the pull cord on a Weed Eater Blower may have become stuck is because the spring broke. You can try to take it apart to fix it, but it can be difficult. The best option is to bring it into a repair shop.
A stuck chainsaw ripcord is likely jammed. Remove the spark plug to see if that allows you to pull the cord. If it still won't pull remove the cover in order to see if the flywheel is able to move.
lol ,, yhuu have theww pull itt backk or call for helpp
The dog house on your recoil is broken or stuck. It's the thing that pops out and engages the shaft when you pull on it, it goes back in when you release the rope.
you will have to pull back the carpet inside the trunk..pull on the cable..it should open ...... then go to 'fueldoorfix.com' a $20 permanent fix
You can start it by using the pull cord, just be sure the key is in the ON position.
it depends on what it is on.
Some cars have an emergency pull tab on the inside of the truck to release it. Look for that first. If not have someone open it if you are stuck inside it. May be able to see the latch from the inside and pull the cord if it has one.
To replace the generator pull cord, first, remove the old cord by unscrewing the cover and pulling out the remaining cord. Next, thread a new cord through the hole in the cover and tie a knot at the end. Wind the cord around the pulley and reattach the cover. Finally, test the new cord by giving it a gentle pull to start the generator.