0
Bus bars are used in Motor Control Centers (MCC) and high voltage switch gear. These copper bars are used in place of wire that would be hard to bend and fit into tight cabinet spaces. The copper bars are easily formed into odd shapes toaccommodate connections of the incoming power source to internal equipment. The bars are easily extended if another section has to be added on for future expansion. In an MCC, if more motor sections are needed the new panel is just bolted to the old bus bars for a continuation of the power to the new section. Because of the amperage of some equipment, single wire just does not have the capacity to handle the current.
What else can I help you with?
What functions are controlled via the data bus as the rain sensor detects rain?
Wht
What is the functions of bus bar in an electric substation?
its a type of conductor that carries electric power
What is difference between Token Ring Token Bus?
In a token bus network architecture, the nodes at either end of the bus do not actually meet. In a token ring, the network logically functions as a ring, but is wired as a star.
What part of speech is bus stop?
The term "bus stop" functions as a noun. It refers to a specific location where buses pick up and drop off passengers. In this compound noun, "bus" acts as a modifier that describes the type of stop.
What are the key components and functions of a DC bus system in an electrical power distribution network?
The key components of a DC bus system in an electrical power distribution network include a power source, a busbar, circuit breakers, and loads. The functions of a DC bus system are to distribute power from the source to the loads, regulate voltage levels, and provide a stable power supply to the connected devices.
Harish goes to school in the bus - Is school noun?
Yes, in the sentence, "Harish goes to school in the bus.", the word school is a noun, a word for an educational facility, a word for a thing.The word 'school' also functions as a verb and an adjective.
What is an explanation of the 8288 Bus controller?
inteT 8288 BUS CONTROLLER FOR iAPX 86, 88 PROCESSORS Bipolar Drive Capability Provides , The Intel"' 8288 Bus Controller is a 20-pin bipolar component for use with medium-to-large iAPX 86, 88 , ). ÂËN I Address Enable: AEN enables command outputs of the 8288 Bus Controller at least 115ns after , of two ways dependent on the mode of the 8288 Bus Controller. I/O Bus Mode - The 8288 is in the I/O , no arbitration is present. This mode allows one 8288 Bus Controller to handle two external busses. No ... OCR Scandatasheet7 pages,239.68 Kbmultiprocessor 8089 intel 8288 bus generator 8288 8284 clock generator pin diagram of 8288 bus controller 8288 bus controller signal 8288 bus controller by intel intel 8288 bus controller intel 8288 8288 bus controller datasheet abstractdatasheet frameAbstract: 8288 Bus Controller DISTINCTIVE CHARACTERISTICS g • Bipolar drive capability • Multi-master or I , OPTION Not Applicable c. DEVICE NUMBER/DESCRIPTION 8288 Bus Controller b. PACKAGE TYPE P = 20-Pin , HIGH. This mode allows one 8288 Bus Controller to handle two external buses. This allows the CPU to , , the 8288 functions in the I/O Bus mode. When LOW, the 828B functions in the System Bus mode. 12 AIOWC , to read a Cascade Address from a master Priority Interrupt Controller onto the data bus. PDEN (IOB ...
When was A Bus for a Bus on the Bus created?
A Bus for a Bus on the Bus was created on 1979-07-25.
What is ALE in 8085 in microprocessor?
ALE=Address Latch Enabled.(pin number 30 in 8085)8085 has a special pin referred as ALE, which indicates whether multiplex bus functions as an address bus or a data bus. Whenever 8085 starts any new operation, ALE signal goes to logic 1 for about 1/2 clock cycle, at about the falling edge of CLK. If ALE=1 then multiplex bus functions as address bus. After that half clock cycle, it goes to logic 0 for nearly 3 or 4 clock cycles. If ALE=0 then multiplex bus acts as a data bus.The ALE pin helps to enable the latching of lower order ADDR bus. The AD0-AD7 pins, as well as other control pins such as S0, S1, IO/M-, and the other address pins A8-A15, are setup to be correct at the falling edge of ALE.
What are two other names for the system bus?
System bus, memory bus, front side bus (FSB), host bus, local bus, or external bus.
What are two other names for system bus?
System bus, memory bus, front side bus (FSB), host bus, local bus, or external bus.
What number school buses have at cub run elementary school peen laird?
bus 159 bus 209 bus 35 bus 96 bus 186 bus 207 bus 153 bus 176 bus 226
