Not unless you want to be Killed or Injured for life. A lot of people have tried to beat the train to the crossing and it was the last thing they Ever did. Train Versus Human = Train 1 - Human Nothing but blood and guts.
* Added - In all US states, the flashing lights activated means stop prior to entering the crossing. If there are no crossing gates, most US states allow you to proceed after stopping and checking to be sure no train is approaching. If there are crossing gates as well, it is not legal to drive aroound the gates or through the crossing while the gates are going up or down in any state in the US.
Active crossing. A highway-railroad grade crossing that has flashing lights with or without crossing gates is called an "active railroad crossing". This is because it is activated automatically by the approach of a train, and shut off as the train passes. In the US, there are crossings that may use flashing lights that are not activated automatically, but nearly all were retired in the US by 1990. The watchman controlled flashing light grade crossing in southern New Jersey made headlines when it was retired in 1990, as the last of its kind in the country.
No. It's a positional device. When the train is a certain number of feet from the crossing it is activated.
The flashing red lights outside of Roscoe, TX, typically indicate a railroad crossing. These lights are activated when a train is approaching, warning motorists and pedestrians to stop and ensure safety. It’s crucial to heed these signals to prevent accidents at the crossing. Always be alert when driving in areas with railroad tracks.
You should stop at a railroad crossing with mechanical gates and lights whenever the lights begin flashing. Do not attempt to cross while the gate is being closed.
(in the US) Some cities and towns have installed a system at major intersections that can be activated when an emergency vehicle (fire apparatus - ambulance - police) are on an emergency assignment and approaching that interesection. The flashing strobe is an indication to motorists to be alert for emergency vehicle traffic and be prepared to stop regardless of the indication of the regular traffic lights.
When approaching a railroad grade crossing where the gates are down or the lights flashing you should stop before the stop line. If there is no stop line then at least 15 or more feet from the nearest rail.
A passive crossing is marked by signs, pavement markings, and sometimes flashing lights or gates to indicate the presence of a railroad crossing. Drivers must stop and yield to oncoming trains.
Drivers may only cross the tracks of an unguarded railroad crossing secured by a flashing light after the lights have stopped flashing and it is safe to do so. It's important to ensure that no train is approaching from either direction, as the signals indicate that a train is near. Additionally, drivers should always exercise caution and look both ways before crossing, even after the lights have stopped.
belisha beacons
15 Feet
When ever the red lights flash at railroad crossings you should stop at least 15 feet from the nearest rail. Flashing red lights at a railroad crossing are essentially the same as a red light at an intersection. You can be cited for not stopping in either situation. When it comes to railroad crossings it is much better to be safe than sorry. When a train hits a car the casualty rate to the occupants of the car is almost 100 percent.
The train whistle or the red warning lights flashing is the first warning signal of an approaching train on a level crossing. At many railroad crossings, the stop arm would be blocking access to crossing the tracks.