It can, if the switch is wired into the common side of the circuit and not the hot side. This is not normally the case, and is almost never the case in modern light fixtures. The situation occurs more often in older fixtures.
The OFF position on the light switch interrupts the flow of electricity to the light bulb. If the switch is ON, there is always electricity at the light socket, even when the light bulb is removed. if the lamp is still pluged in electricity is still flowing through the lamp even if it is off or on
Yes, electricity is wasted if a socket is switched on but not being used because the electricity is still flowing through the circuit even though no device is drawing power.
To extend the reach of your outdoor light socket using an outdoor light socket extender, simply plug the extender into the existing socket and then plug your light fixture into the extender. This will allow you to position your light fixture further away from the original socket while still receiving power.
No, a light fixture does not consume electricity if there is no bulb in it. The bulb is what generates light when electricity passes through it, so without a bulb, there is no circuit to complete and no electricity is being used.
If the bulb lights up then electricity is passing through the bulb. If the bulb doesn't light up then electricity is not passing through.
Yes, you can still get electrocuted even if your feet are not on the ground, as electricity can travel through various conductive materials. For instance, if you're in contact with a conductive surface or object that is connected to an electrical source, the current can flow through your body. Additionally, being suspended in the air does not prevent electrical current from passing through you if you're in contact with an electrified object. Always take precautions around electricity, regardless of your position.
Yes, you are still using electricity.
No power is used. The lamp in the light fixture is the load of the circuit. The load resistance is what makes the current flow. When the current flows through the filament's resistance, heat and light are generated. With no lamp in the fixture, the circuit's voltage potential is still at the socket contact points and if touched could cause you a shock. This is a good reason to shut the fixture off at the switch when removing the burnt out bulb and replacing it with a new one.
No, unless there is an indicator light in the socket.
if we add some sulphuric acid or NaOH and then pass electricity through the water, then electrolysis of water takes place and hydrogen and oxygen gases are formed.
yes.. Through Hydrolysis but you still need electricity to produce the gas.
Of course you can. It just can't enter or leave your body through your feet. But you can still conduct plenty of electricity, and hurt yourself badly, if it goes in one hand and out the other, for example, straight through your heart.