How do you make a gay pride bracelet?

Answer 1

You get red, orange, yellow, green, blue, and purple beads, along with some thin elastic bracelet-making wire. There are two ways to do it once you have those. The first and third steps are the same.

1) tie a knot about an inch from the end of the clear wire.

2) You can either put all the red together, followed by the orange, then yellow, then green, then blue, then purple

OR

Make a pattern of one red, one orange, one yellow, one green, one blue, one purple, and repeat it until you are about an inch away from the other end.

3) Tie the knotted end and the other end together, and put on your new PRIDE bracelet!

But make sure the holes in the middle of the beads are thin enough to not slide over the knot as you are putting them on!