Aggregate, typically composed of sand, gravel, or crushed stone, is not considered a renewable material because it is extracted from natural sources that take thousands to millions of years to form. While some aggregates can be recycled from construction and demolition waste, the primary sources are finite. Thus, their availability is contingent on mining and extraction practices, which can lead to environmental degradation. Sustainable practices can help manage aggregate use, but they do not make it renewable in the traditional sense.
Construction material.
The weight of 10mm aggregate varies based on the density of the aggregate material. On average, the weight can vary between 1400 to 1600 kg/m3, so for a specific weight, you would need to know the density of the aggregate material being used.
A plant and plant based material is considered renewable.
wages and raw material effect short run aggregate supply because of productivity factor but money is neutral in the long run so will never effect long run
no
No, polystyrene is not considered a renewable material. It is a synthetic polymer made from petroleum, a non-renewable fossil fuel. While there are efforts to develop biodegradable alternatives and recycling methods for polystyrene, the material itself does not come from renewable sources.
it is a material that can not be made again after it has been used up.
Fecal material is a biomass and is renewable.
Aggregate is the gravel or stone in the concrete. It is what gives concrete it's strength. Think of the aggregate as the bricks of a wall and the concrete and sand as the mortar.
It depends on the material of the toy..
A material that can be replaced after it is used is called a renewable resource. Examples include wood, solar energy, and wind energy.
When used as a base for roads or buildings, aggregate adds structural stability and improved drainage. But this advance site preparation adds significantly to cost and time of the project.Adding aggregate to a composite material such as concrete or mortar can both lower the cost and raise the plasticity of the material. However, strength of these materials is lessened.