0
1995-2005 Chevy Cavaliers
The 1995-2005 Chevy Cavalier was the third generation Cavalier model produced by General Motors. In 1996, the Cavalier Z24 received the new LD9 2.4 liter engine along with the Getrag F23 5-speed manual transmission.
7,016 Questions
check your transmission fluid or it may be something electrical if your cavalier transmission is run by electronics. If not it may be a sun gear inside the transmission so you may need to get the transmission rebuilt.
How come a Transmission on a 1995 cavalier will not go into drive or reverse?
There are several things that can cause your 1995 Chevy Cavalier transmission not to go into drive or reverse. The most common cause is a lack of transmission fluid. A broken shifting fork will also cause the problem.
How do I wire in new speakers for my 2002 Chevy Cavalier?
To wire new speakers, you will need to remove your existing speakers first. Check your owners manual to find the location and instructions.
Have a 2005 cobalt with key stuck in igintion?
If a key is stuck, try turning it and making sure the key is in the off position. Next try some lubricating spray meant for cars, it should help get it out.
How many mpg does the 1997 cavalier get?
The 1997 Chevy Cavalier gets an average twenty-four miles per gallon. This nice little car gets twenty-one in the city and twenty-nine on the highway.
This was according to the U.S. Department of Energy. I hope this was satisfactory.
WHEN ITS WARM OUTSIDE AFTER RUNNING ITS SPITS AND SPUTTERS?
It is possible that your car has a faulty oxygen sensor that is effected by the humidity and heat. This will create a rich or lean fuel mixture causing the car to sputter. It should be brought to a mechanic for a tune up.
How many quarts of oil go into 2000 chevey cavalier?
Engine oil with filter change 4.0 quarts to 4.5 quarts
Where is the brake relay switch located on a 1998 Chevy cavalier?
The 1998 Chevrolet Cavalier brake relay switch can be found below the dashboard, on the drivers side of the passenger compartment. The brake switch simply plugs in and out.
What has occurred when HDD fails making a grinding noise?
a. controller failure b. the read/ write head is in contact with the platter c. hard drive is in power save d. hard drive is in labor
I have a 1998 cavalier that the theft system needs reset?
The easiest way to reset your 1998 Chevrolet Cavalier theft system is to remove the fuse. Keep the fuse out for 10 seconds and replace it to its original slot.
Why does the ets light then check engine light come on when my car gets warmed up on a 96 cavalier?
The Enhanced Traction System warning light will come on during wheel slip. When it comes on with no wheel slip one of the sensors is bad. You can have the code pulled for free at most auto parts stores to find out what sensor is throwing the code.
1995 Chevy cavalier crankshaft position sensor location with a 2.2L engine?
http://autorepair.about.com/library/illustrations/bl100a-lib.htm
Here is a complete diagram to where it is....very nicely illustrated on this one...M0rningangel1@aol.com
What if Service Vehicle Light on with ABS light and Traction support light?
re: bad regulator in the alternator
WRONG ANSWER. these lights, when on at the same time, mean one that you will need to change one of your wheel bearings. You will need to have the vehicle scanned to determine which of the four is in need of replacement.
Where check the transmission fluid on a 1999 cavaler?
The transmission dipstick is on the front of the engine on the drivers side. This is the place to check as well as add transmission fluid.
Camshaft timing mark 96 Camry 2.2l?
The only marks you need to be concerned with are on the rear of the cam gears, there are two large dimples, these are the assembly marks, not the timing marks, line them up and then rotate the camshafts to the top dead center position, there should be two small dots that line up with the single dot inbetween.
The reason for the assembly marks is that the one of the cams has a spring loaded gear, you can identify it because it has a two piece gear, before you remove the cam you have to install a short bolt into one of the holes in the gear so that it won't unwind, the reason you need to use the assembly marks is that the service bolt is not accessible with the cams at top dead center so you assemble it with the marks so that you can then remove the bolt and then rotate the cams to the #1 firing position.
The only marks you need to be concerned with are on the rear of the cam gears, there are two large dimples, these are the assembly marks, not the timing marks, line them up and then rotate the camshafts to the top dead center position, there should be two small dots that line up with the single dot inbetween.
The reason for the assembly marks is that the one of the cams has a spring loaded gear, you can identify it because it has a two piece gear, before you remove the cam you have to install a short bolt into one of the holes in the gear so that it won't unwind, the reason you need to use the assembly marks is that the service bolt is not accessible with the cams at top dead center so you assemble it with the marks so that you can then remove the bolt and then rotate the cams to the #1 firing position.
What would putting 5 quarts of oil in a 2003 caviler do to the engine and seals?
Adding 5 quarts of oil to an engine and overfilling it can cause the seals to blow out. This can cause engine failure.
What does the indicator light TC with a slash through it mean for a 2001 Chevy Cavalier?
traction control is off.
What size speakers front and rear are in a 1996 cavalier?
FRONT DOOR 6"X 4" Dule cone Model 16220119 REAR DECK 6"X 9" Dule Cone Model unknown any 6x9 will fit
Where would the trunk release button on a 1998 Cavalier Z24 be located?
I believe it is a yellow button under the left side of the dash on the drivers side about where your knee would be. Either that or in the glove compartment.
Why does the car shake when braking at high speeds?
A car shaking while applying brakes is most likely caused by worn a brake pad. Check the brake system at all four wheels to find the problem.
How do you deactivate the factory anti-theft system on a 1999 cavalier?
The easiest way to deactivate the 1999 Chevrolet Cavalier antitheft system is to remove the fuse. The location of the antitheft system fuse will be listed on the inside cover of the fuse box.
If one headlight is out all others working on 2001 Chevy cavalier good fuse good bulb.Wiring issue?
cheack all the hook ups make sure there tight then if it still doesnt work fallow the wires runing out of the back of the bulb and cheack it there shorted out any where, u will c a little black burnt spot on ur wire, if u do clip it and get a new wire or splice the wire back to geather.
The ABS light and the ETS light on my 1998 Cavalier stay on after it is startedwhy is that?
I am having the same problem and sometimes it stalls my car. It started shaking a lot when i tried to turn it on this morning and i had to pump the gas a few times, i read this.
I would have a mechanic remove each ABS sensor, using an external torx wrench, and clean it with a spritziled rag (don't use compressed air). Should be a very simple job. See if this solves the problem before doing anything else.
My experience with other people, who have had the ETS light come on, is that it often indicates a weak ignition system. Begin by replacing the platinum spark plugs with the exact ACDelco plugs that came in the car (likely Part No. 41-928). Also, replace the fuel filter.
Why 1998 cavalier low beam headlights not working?
To find the cause of the low beams not working, start with the bulb to make sure both are ok. Check the dimmer switch, and the wiring from the switch to the headlights.
