Why does it take your Chrysler van four or five cranks to start?
If it is four or five turns of the starter normal.
If it is four or five times that you turn on and stop then try again, usually loosen fuel pressure. Leaking fuel injector or a fuel pump leaking down.
When was Dodge taken over from Chrysler?
NOT it is part of the Chrysler Company since they purchased it from the Dodge Brothers.
Where is the cabin air filter located on a 2005 Chrysler 300?
If equipped, it was an option, it is under the wiper cowl. Passenger sside, under the hood. There There is an access door near the base of the windshield.
How much does it cost to repair head gasket 1999 Chrysler 300m?
Depending on the engine ball park $700.00 to $1500.00 or higher if the heads are warped etc. There are two heads, never replace just one gasket.
How do you reset the service indicator light on a Chrysler grand voyager 2006?
Have the engine controller checked for faults then serviced and the light turned off. Take it to the dealer.
How do you replace mode door actuator on a 2000 chrysler 300m?
1. remove the radio bezel , unplug plug
2. remove radio , unplug plugs
3. remove left and right vent ducts
4. remove center vent duct
5. remove actuator three 8mm screws , remove plug
6. installation is reverse
How do you change front wheel bearing on a 2000 Chrysler 300?
Remove wheel then remove the big nut that holds the axle to the hub. Remove the brake caliper and rotor, through the hole in the face of the hub(where the wheel studs are) remove bolts that hold the hub and bearing to the steering knuckle. Tap hub and bearing assy from knuckle. The hub and bearing is one part.
How many axles does a chrysler pacifica have?
Front and rear, so two.
Now if you are asking about axle shafts, a fwd has two, a left and right in the front. An AWD has four, the front ones and a left and right rear.
How many fuses boxes on a Chrysler concorde 1997?
Two. One under the hood and one on the driver side end of the dash.
Where is gas tank button on 2010 Chrysler 300?
I believe you simply push the left side of the gas flap in and the right side opens up.
Did Dodge or Chrysler use the 383 engine first?
It was introduced in 1961 and available in all Chrysler makes.
How do you replace ignition key cylinder in Chrysler?
You normally have to remove the steering wheel and take apart part of the steering column. If your car has an air bag in the steering wheel you will probably want to take it to a garage. A Haynes Manual for your vehicle would tell you how to do it or whether to attempt it.
Depending on the car, you might not need to take apart the steering column, but you will probably still have to remove the air bag and steering wheel. Often, there is a pin or some kind of interlock that you can push to remove the lock cylinder, but you can only get to it after removing the steering wheel. Again, see the service manual for the specific vehicle.
In June of 2009, as reported by the Los Angeles Times, finalized its purchase of controlling interest of the Chrysler corporation, the parent company of Jeep.
In 1987 Chrysler Corporation acquired American Motors Corp. for 800 million who owned and produced at that time.
In 1998 Daimler-Benz merged with Chrysler.
In 2007 Cerberus Capital Management purchases controlling interest in Chrysler with Daimler-Benz still maintaining a portion.
As of 2009 The U.S. government owns 8%, Canada owns 2%, Fiat owns 20%, the United Workers union's retiree health care trust owns 55%. The remaining 15% is being held in reserve by the U.S. to be doled out to Fiat if it meets certain performance goals. [USA Today - See Link]