Massey Ferguson

on mine all I did was pry up on both sides of the knob and it pops right out

Alot

On the left side of the gear shifters

To change the oil in a Massey Ferguson 135 tractor refer to the books instructions. The instructions will guide you on where to drain the oil, what oil to use, and how to replace.

10 1/2 feet long

what kind of hydraulic oil should be used for a massey furguson 245

10 horse power

The 1500 series are fairly new, they came around 2004.

8 gallons use a suitable replacement oil for part # M1127-M1129A

1973

Between 65-70 depending on serial number.

That is at least a 1975 tractor.

What model is it?

I think they hold around 53 litres for power shuttle transmission

it weighs about 1.5 tone and has about 20 horse power which is good on a farm

how do i take the brakes out of a massy165

8,430 lbs [3823 kg]

this is the operating weight of a 4355 with cab and 4wd

Check out the site tractordata.com! The number is supposed to be located on the instrument panel below the steering column.

Weight (shipping): 2,982 lbs [1352 kg] (gas)

Weight (operating): 3,559 lbs [1614 kg] (diesel)

Weight (ballasted): 5,909 lbs [2680 kg]

This was taken from the website link given below...

Had the same problem with a MF 3660. Pressure always shows O.K. on gauge even when low pressure warning light comes on. Green wire going into the ETCU mainboard, the one with the 2 screws holding the male connetor to the mainboard is the source of the loose connection causing intermittent on off of the low pressure warning light. This causes the autotronic to disconnect the low pressure clutch packs (p.t.o. and M.P. as well as main range selector. Wingling the connector at the mainboard sometimes corrects the issue but usually only for a short time. The cure is to remove the 2 mini screws that hold the male conector to the mainboard and jently pry the multi pronged connector from the eproxy mainboard.Once removed gently sqweeze and retaper the male prongs using a vise grip. This will taper the prongs so that they form a tighter wedge as they reenter the epoxy board. Worked for me and saved a few grand for a mainboard replacement.

The oil capacity for a Massey Ferguson 271 XE tractor is approximately 6.6 liters (1.74 gallons) when using a standard engine oil filter. It's important to check the owner's manual for precise specifications and recommendations, as oil capacity can vary slightly depending on specific configurations or modifications. Make sure to use the appropriate oil type for optimal performance.

It doesn't sound as though you have the proper number. The number should be located on the instrument panel below the steering column as shown at tractordata.com. You should check it out!

theres is not one you can get this filter from massey or jacks small engine i just got one

I think it is somewhere between 1976 and 1979. Mine is a 1980 SN 20605

Crosses to a Baldwin Filter PT258... see www.baldwinfilter.com

21 hp engine and 17 hp pto