0
Smith and Wesson
The leading gun manufacturer in the US, Smith and Wesson is a company that provides services and products for security, safety and sport. The company also provides related training to the law enforcement, military and sports markets.
4,780 Questions
Testing a safety on a SW single action revolver?
The only "safety" is you. You can test for "push off" by cocking the revolver and attempting to "push" the hammer forward with your thumb. This will let you know if there is unacceptable part wear.
What is the value of 38 smith Wesson airweight ctg 5 shot silver plated with wood grips?
100-1000 USD
Age and value 38 Smith and Wesson Special CTG K 137329?
Call S&W and they will tell you when it left the factory. It could have been made a week to a year before. 100-300 USD
SW 38 special markings 971490b459043?
No such marking with that many numbers and letters in that configuration was ever put on a S&W
How do you disassemble a smith and Wesson model MP?
A Smith and Wesson M&P model is a 6 shot revolver in 38 Smith & Wesson Special caliber. The MP or M&P stands for "military and police".
To disassemble the revolver, first remove the grip screw from the left side of the revolver as the revolver barrel faces to the left.
When the grips are removed the side plate will be fully visible.
Remove the screws from the side plate.
To remove the side plate, hold the revolver to the horizontal position with the side plate facing down. Do not pry off the side plate as that will damage the side plate fit.
Sharply rap the now exposed grip frame with a wood or plastic hammer until the side plate loosens. Continue to rap, and the side plate will fall off along with the hammer block, so be sure it falls on a padded surface.
At this point most internal parts will be visible and accessible.
The cylinder can be removed by sliding the cylinder crane to the left and out of the frame, while holding the cylinder in place.
The cylinder will now be free.
To reassemble the revolver, do the above in reverse, making sure the hammer block is in place and the side plate seats correctly.
You can tap on the side plate with a wood or plastic tool to seat it properly.
Replace the cylinder crane and cylinder. Be sure the correct screw is used to hold the cylinder crane to the frame.
Replace the remaining side plate screws in the correct place along with the grips and grip screw.
Holding back the hammer slightly, or with the hammer cocked, look in the gap between the hammer and frame to be sure the hammer block has been replaced.
A word of caution here: know exactly what you are doing before making alterations or repairs. Revolvers are delicate and expensive machinery.
How do you take apart a smith and Wesson 40 cal VE?
You can get a free owner's manual from S&W via their web site.
How do you assemble smithwesson 38 ctg?
Any good reloading manual will get you started on assembling 38 special ammunition.
What year did smith and Wesson make the 686-3.?
The 686-3 was introduced in 1992 from the 686 which was made in 1988.
300-500 USD
100-400 USD
What is the age of smith and Wesson 32 ctg serial number 254166?
Call S&W and they will tell you when it left the factory. It could have been made a week to a year before.
How old is a smith Wesson model 59 with serial number 405355?
Call S&W and they will tell you when it left the factory. It could have been made a week to a year before.
