It depends on how its connected and how much current the camera needs to run on. The "1050ma" figure is the capacity of the battery not how much current the camera uses and it should read 1050mah which is a capacity measurement not a current measurement.
no
No. The adaptor will overheat.
No. an AC adapter will not work for equipment that needs DC.
No, the adapter's power output has to be equal to or greater that the current draw of the device.
Yes, you can use a 300mA adapter on a 1A device, but it may not work properly or could damage the adapter. The device may draw more current than the adapter can provide, leading to insufficient power, potential overheating, or failure of the adapter. It's always best to use an adapter that meets or exceeds the device's current requirements for optimal performance and safety.
No, a power adapter must supply the same voltage, same polarity, and at least as much current as the load requires. Your adapter can only supply 300mA, which is less than the 700mA required by the load.Your game probably will not turn on and the power adapter may be damaged.
Yes, you can recharge a 6V 500mA battery with a 6V 300mA charger. The charger with lower current (300mA) may take longer to fully charge the battery compared to a 500mA charger, but it should still work. Just ensure you do not exceed the voltage rating of the battery.
Contact the manufacturer of the 'phone or visit a telephone retailer.
difference is 2.7 amperes in numbers will be 12 volts 3 amps and the other will be 12 volts .3 amps
Yes, you can charge a 12V 7.2Ah battery with a 12V 300mA charger, but it may take a long time to fully charge the battery due to the lower current output. The charger will provide a safe voltage for the battery, but the charging time could be significantly extended compared to a charger with a higher current output. Ensure the charger is compatible with the battery chemistry to avoid any damage.
No, you will burn out the camera. You can pick up the correct mini spy camera power adapters in the "Related links" section just below this box.
300mA (or milliamperes) is equal to 0.3A (or amperes).