answersLogoWhite

0

(config)#no interface loopback x

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

What is a characteristic of an IPv4 loopback interface on a Cisco IOS router?

The IPv4 loopback interface on a Cisco IOS router is a virtual interface that is always up and operational, regardless of the physical state of the router's interfaces. It is typically assigned the IP address 127.0.0.1, but any valid IP address in the loopback range (usually 127.0.0.0/8) can be used. This interface is commonly utilized for testing and management purposes, as it allows for local communication within the router itself without relying on physical interfaces. Additionally, it is useful for routing protocol configurations and as a stable endpoint for various network services.


Which encapsulation protocol when deployed on a Cisco router over a serial interface is only compatible with another Cisco router?

HDLC


What is the command line interface used for on a cisco router?

Cisco IOS uses a command line interface (CLI) for inputting commands when configuring Cisco Routers


What is the command line interface used for a Cisco router?

Cisco IOS uses a command line interface (CLI) for inputting commands when configuring Cisco Routers


On a Cisco router what interface is used to make the initial configuration?

console port


What mode must be in to configure IP address on a Cisco router?

interface mode


What comment are use to delete a routing protocols in cisco router?

No router eigrp <AS #> No router ospf <process ID> No router bgp <AS #> No router rip


What is global router configuration?

I'll go to hellis Cisco in a Cisco router. What would the prompt look like for global configuration


On a Cisco router which interface would be used to make the initial configuration?

Ask in the computing category.


How do you remove a static route from a routing table?

Assuming you have a Cisco router, you add a static route with the command ip route.... Therefore, you delete it with the command no ip route....Assuming you have a Cisco router, you add a static route with the command ip route.... Therefore, you delete it with the command no ip route....Assuming you have a Cisco router, you add a static route with the command ip route.... Therefore, you delete it with the command no ip route....Assuming you have a Cisco router, you add a static route with the command ip route.... Therefore, you delete it with the command no ip route....


How can someone get the frequency on a Cisco 2801 router to go a further distance?

You can get the frequency on a Cisco 2801 router to go a further distance by increasing the density of the interface and that of the inline power output. This is best done by a professional.


What does it mean when a user sees the command prompt Router config-if?

On a Cisco router, that means that you entered interface configuration mode; any command you give will affect the selected interface. For example, you may have given the commands:Router>enableRouter#configure terminalRouter(config)#interface FastEthernet 1/0Router(config-if)#On a Cisco router, that means that you entered interface configuration mode; any command you give will affect the selected interface. For example, you may have given the commands:Router>enableRouter#configure terminalRouter(config)#interface FastEthernet 1/0Router(config-if)#On a Cisco router, that means that you entered interface configuration mode; any command you give will affect the selected interface. For example, you may have given the commands:Router>enableRouter#configure terminalRouter(config)#interface FastEthernet 1/0Router(config-if)#On a Cisco router, that means that you entered interface configuration mode; any command you give will affect the selected interface. For example, you may have given the commands:Router>enableRouter#configure terminalRouter(config)#interface FastEthernet 1/0Router(config-if)#