0
What else can I help you with?
What is cisco iso?
The Cisco ISO is the "Operating System" of the Cisco device. The user can configure the device by accessing and changing the configuration in the ISO.
In a Cisco router when do changes made to the running-configuration take effect?
as the commands are entered
In a Cisco IOS device where is the start-up configuration file stored?
NVRAM
How do you give ip address in serial port?
To assign an IP address to a device connected via a serial port, you typically use a terminal emulation program (like PuTTY or Tera Term) to access the device's command-line interface. Once connected, you can enter configuration commands specific to the device's operating system, such as ip address [IP_ADDRESS] [SUBNET_MASK] in Cisco IOS. Be sure to save the configuration after making changes. The exact commands may vary depending on the device and its firmware.
What is the the sequence of commands for setting the enable secret to Chile?
To set the enable secret to "Chile" on a Cisco device, enter the following commands in configuration mode: Access the global configuration mode by typing configure terminal. Set the enable secret by typing enable secret Chile. Exit the configuration mode by typing exit or end. Make sure to save the configuration with write memory or copy running-config startup-config if necessary.
Which of the following commands sets the secret password to Cisco?
In the global configuration mode, type enable secret See below example:Router>enableRouter#configure terminalEnter configuration commands, one per line. End with CNTL/Z.Router(config)#enable secret passwordRouter(config)#exitRouter#
What is a result of using the service password-encryption command on a Cisco network device?
All passwords in the configuration are not shown in clear text when viewing the configuration.
What do the commands for the Cisco switch IOS allow the user to do?
The Cisco IOS commands allow the user to enter partial Cisco IOS commands. If you start to type in a command it can recognize it and finish the command for you.
What is accomplished by the command copy tftp running-config?
This command will allow you to copy a configuration from a TFTP server to the running configuration of a Cisco device. When you issue the command you will be prompted for further details about the TFTP server. The new configuration will replace the active one (or running configuration) and make any necessary changes.
How do you empty startup or running configuration command on cisco?
To empty the startup configuration on a Cisco device, you can use the command erase startup-config in privileged EXEC mode. To remove the running configuration, you can use the command write erase followed by reload to restart the device, which will clear the running configuration and load the default settings. Remember to save any necessary configurations before performing these actions, as they will result in data loss.
Which commands do you use to display interface status and configuration information about the local device?
Show CDP Interface
What command displays the configuration stored in NVRAM?
wr or copy running-config startup config
