# Twisted pair - Wire twisted to avoid crosstalk interference. It may be shielded or unshielded. #* UTP-Unshielded Twisted Pair. Normally UTP contains 8 wires or 4 pair. 100 meter maximum length. 4-100 Mbps speed. #* STP-Shielded twisted pair. 100 meter maximum length. 16-155 Mbps speed. Lower electrical interference than UTP. # Coaxial - Two conductors separated by insulation such as TV 75 ohm cable. Maximum length of 185 to 500 meters. ## Thinnet - Thinnet uses a British Naval Connector (BNC) on each end. Thinnet is part of the RG-58 family of cable*. Maximum cable length is 185 meters. Transmission speed is 10Mbps. Thinnet cable should have 50 ohms impedance and its terminator has 50 ohms impedance. A T or barrel connector will have no impedance. Maximum thinnet nodes are 30 on a segment. One end of each cable is grounded. ## Thicknet - Half inch rigid cable. Maximum cable length is 500 meters. Transmission speed is 10Mbps. Expensive and is not commonly used. (RG-11 or RG-8). A vampire tap or piercing tap is used with a transceiver attached to connect computers to the cable. 100 connections may be made. The computer has an attachment unit interface (AUI) on its network card which is a 15 pin DB-15 connector. The computer is connected to the transceiver at the cable from its AUI on its network card using a drop cable. Maximum thicknet nodes are 100 on a segment. One end of each cable is grounded. 3. Fiber-optic - Data is transmitted using light rather than electrons. Usually there are two fibers, one for each direction. Cable length of 2 Kilometers. Speed from 100Mbps to 2Gbps. This is the most expensive and most difficult to install, but is not subject to interference. Two types of cables are: 1. Single mode cables for use with lasers has greater bandwidth and costs more. Injection laser diodes (ILD) work with single mode cable. 2. Multimode cables for use with Light Emitting Diode (LED) drivers. All signals appear to arrive at the same time. P intrinsic N diodes or photodiodes are used to convert light to electric signals when using multimode.
{| ! Media ! Distance(meters) ! Speed ! Approx Cost/station | UTP 100 4-100Mbps $90 STP 100 16-155Mbps $125 Thinnet 185 10Mbps $25 Thicknet 500 10Mbps $50 Fiber 2000 100Mbps-2Gbps $250 (multimode) |}
communication media are the physical components through which the communication devices transmit data. e.g. cables, telephone lines, terminals.
Various media are used for data communication. Communication media refers to the means of delivering and receiving data or information. In telecommunication, these means are transmission and storage tools or channels for data storage and transmission.
There is no physical connection between two system in CASE OF UNGUIDED MEDIA
Mediums of communication have several types. These can be verbal, written and non-verbal. Some examples of mediums use of communication are emails, SMS, social media, personal letters, television, radio and newspapers.
if you know the answer plz help!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! physical and air are the two mediums of electronics and communication
to convert a frame into a series of signals to be transmitted on the local media
guided media is a communication medium which allows the data to get guided along it .For this the media need to have a point to point physical connection
to convert a frame into a series of signals to be transmitted on the local media
to convert a frame into a series of signals to be transmitted on the local media
Mass refers to the amount of matter in an object, while media refers to the communication channels used to distribute information to a large audience, such as television, radio, and internet. Mass is a physical property, while media is a means of communication.
communication vide media
Based on the language used, communication media can broadly be categorized into two types: Verbal media and Non verbal media. Various media of communication are shown in the following diagram: 1. Verbal Communication: When information is exchanged through words, it is called verbal communication.