0
What else can I help you with?
Give the clock out frequency and state time T of 8085 when the crystal frequencies is 5MHz?
The clock out frequency of an 8085 is one half the crystal frequency. The period of one T cycle is the inverse of the clock frequency. At a crystal frequency of 5MHz, the clock is 2.5MHz, and T is 400 ns.
How do you calculate minimum clock period in a digital circuit?
If you have the Maximum clock frequency, then you can figure out the minimum clock period using this formula: 1/(minimum clock period) = (Maximum clock frequency).
Use of low frequency clock generator?
How to make Low frequency clock generator using ANAD gates?
What is the clock period of a clock frequency of 1ghz?
The clock period is the time duration of one clock cycle. For a clock frequency of 1 GHz (1 billion hertz), the clock period would be 1 nanosecond (1/1,000,000,000 seconds).
What is the Maximum clock frequency of 8086 microprocessor?
that depends on the microcontroller. check the datasheet.
Why used a clock signal timing diagram?
We use clock signal in timing diagram because the microprocessor operates with reference to clock signals provided to it. At pins X1 and X2 we provide clock signals and this frequency is divided by two. This frequency is called as the operating frequency.
What is the clock frequency of 555 ic timer?
The 555 IC timer does not have a clock.
What is the period of a clock waveform whose frequency is 500 kHz?
The period of a waveform is the reciprocal of its frequency. For a clock waveform with a frequency of 500 kHz, the period can be calculated as 1 / 500 kHz = 2 microseconds.
What is the frequency of a minute hand on a clock?
1/3600 Hz
What is a pulse rate of a clock measured in?
frequency of an oscillator crystal
Specify the crystal frequency required for an 8085 system to operate at 1.1mhz?
The crystal frquency in an 8085 system is twice the desired clock frequency, so a crystal of 2.2 MHz is required to operate at 1.1 MHz.Note: Clock frequency is not the same as instructions per second, because the instructions in an 8085 take a variable number of clock cycles, between 4 and 18, to execute.
What will happen if crystal frequency of 8085 is increased from 5 to 20 MHz?
Since the 8085 has a maximum clock frequency of 6 MHz, increasing the crystal frequency from 5 MHz to 20 MHz, a corresponding clock frequency change of 2.5 MHz to 10 MHz, the chip would malfunction.
