0
What else can I help you with?
Which command sets the encapsulation on a Serial interface back to the Cisco default?
encapsulation hdlc
What is the default encapsulation for serial interfaces on Cisco routers?
HDLC
Which encapsulation protocol when deployed on a Cisco router over a serial interface is only compatible with another Cisco router?
HDLC
Which data link layer encapsulation protocol is used by default for serial connections between two Cisco routers?
HDLC
What is difference between serial interface and Ethernet interface?
The FastEthernet interface of R1 is disabled. One of the default routes is configured incorrectly. A routing protocol is not configured on both routers. The default gateway has not been configured on both routers.
Which three encapsulation types can be set on serial interface by the administrator who is using SDM Express?
1. Frame Relay 2. HDLC 3. PPP
What is synchronous serial input?
synchronous input means that the flipflop reads input only at posedge or negedge of the clock.
Which type of digital transmission should you use?
synchronous serial transmission
Does bluetooth use parallel interface?
No, bluetooth is a serial interface.
What must be configured to establish a serial link between two routers that are directly connected?
To establish a serial link between two directly connected routers, you must configure the appropriate interface settings on both routers, including the serial interface type and IP addressing. This involves enabling the serial interfaces and assigning them IP addresses within the same subnet. Additionally, you may need to set the encapsulation type (e.g., HDLC or PPP) and ensure that clock rates are configured if one router is designated as the DCE device. Finally, verify the link with commands like ping or show ip interface brief to ensure connectivity.
Which component translates a synchronous serial connection to time division multiplexed connection?
The router.
Why set clock rate in router?
To configure the clock rate for the hardware connections on serial interfaces such as network interface modules (NIMs) and interface processors to an acceptable bit rate, use the clock rate interface configuration command. Use the no form of this command to remove the clock rate if you change the interface from a DCE to a DTE device. Using the no form of this command on a DCE interface sets the clock rate to the hardware-dependent default value.
