The debug flag in the 8086/8088 microprocessor causes one instruction to be executed, followed immediately by a debug interrupt. The flag then gets turned off, so you get get nested debug interrupts. This is used by a debugger program to single step a process that it is debugging (the debugee, so to speak).
The 8086 microprocessor has 40 pins.
It is mightily referring to Microprocessor 8086 . I think you saw "8086 microprocessor". The 8086 is nothing it indicates the number of microprocessor same as Digital or analog ic's . 8086 microprocessor has 20 Address buses and 8 data buses which has 1 Mb inbuilt memory for performing several type of airthmatical and logical operation.
queue of 8086 microprocessor is 6 bits
The 8086 Microprocessor operate to require frequency that is provided by clock generator to 8086 Microprocessor and also Synchronization various component of 8086.
it is a 16 bit microprocessor & it has 40 pin .
Pins 1 and 20 in the 8086 microprocessor are (both) power and signal ground (GND).
8086 main application is to evaluate the arithmetic operations in any systems that uses 8086
Which microprocessor accepts the program written for 8086 without any changes?
Two ground pins are used in the 8086 microprocessor to increase the bus pull-down current capacity.
Yes, there are on-board computers with microprocessor 8086 that can be used to measure temperature and pressure. These computers can be equipped with sensors for temperature and pressure measurements, and programmed to process and display the data collected from these sensors in real-time. The 8086 microprocessor is capable of handling the data processing requirements for these measurements.
Its 16bit microprocessor,and-> the 8086 has a 16bit databus 20bit address bus-> the intel 8086,is designed to operate in two modes namely(1) minimum mode(2) maximum mode
ya possible