Netstat -e
Assuming you have a Cisco router, you add a static route with the command ip route.... Therefore, you delete it with the command no ip route....Assuming you have a Cisco router, you add a static route with the command ip route.... Therefore, you delete it with the command no ip route....Assuming you have a Cisco router, you add a static route with the command ip route.... Therefore, you delete it with the command no ip route....Assuming you have a Cisco router, you add a static route with the command ip route.... Therefore, you delete it with the command no ip route....
conf terminal Router#show ip route
the default gateway is the most common static route used in a host computer. netstat -r is the command line command to obtain the routing table.
You use /P with the Route Add command
To isolate problems with a static route in IOS, you can use the following commands: show ip route - This command displays the routing table, allowing you to verify if the static route is present and correctly configured. ping - This command tests connectivity to the next hop or destination address specified in the static route, helping to identify any reachability issues. traceroute - This command traces the path packets take to the destination, which can help identify where the traffic is being dropped or misrouted along the path.
routing table code S
ip route prefix mask address
default-information originate
router(config)#ip route 0.0.0.0 0.0.0.0 10.1.1.1
route#debug ip routing
show ip route
route