0
What else can I help you with?
From what location can a router load the Cisco IOS during the boot process?
TFTP server, Flash
Router command allows the presentation of information during the log on process?
banner motd
Are IP address' assigned to the router or the location of the router?
the router is assigned an ip address.
What is one function of the bootstrap program during the router boot process?
loading Cisco IOS software
What comment are use to delete a routing protocols in cisco router?
No router eigrp <AS #> No router ospf <process ID> No router bgp <AS #> No router rip
What is the total amount of RAM on the router?
A router does not have RAM. A router distributes data. The router does not hold data nor does it process data.
What is different between router and routing?
*router is a device use to route communication or connection *routing is the process *router is a device use to route communication or connection *routing is the process
When would the Cisco IOS image held in ROM be used to boot the router?
during a file transfer operation during a normal boot process when the full IOS cannot be found when the running configuration directs the router to do this
How do you Install the SSID?
A 802.11 Service set Identifier is not installed, it is automatically assigned during the manufacturing process and is broadcasted when a Modem/Router is initialized as the Wireless Access Point. The SSID can be changed in the modem/router settings.
Which command or set of commands will stop the RIP routing process?
no router rip
What determines if the router implements a classless route lookup process?
The command ip classless is enabled on the router.
Run two BGP process on single router?
No, You cannot run two BGP process on a Single Router. Yes, it is possible if you use different VRFs
