An accumulator machine, also called a single accumulator organisation , or a CPU with accumulator-based architecture, is a kind of CPU where, although it may have several registers, the CPU mostly stores the results of calculations in one special register, typically called "the accumulator". Historically almost all early computers were accumulator machines; and many microcontrollers still popular as of 2010
Accumulator contains one of the operand for any operation which is performed by the ALU.The result of the operation is stored in the Accumulator. thus it is a special register
Accumulator is a general purpose register.it is a 8 bit register in 8085. it stores the temporary results of a current operation doing by 8085.it is also called 'A' register
A mechanical, or electrical accumulator???
The 8085 microprocessor is often referred to as accumulator-based because it primarily uses an accumulator register (register A) for arithmetic and logic operations. Most instructions directly operate on the data stored in the accumulator, which acts as the primary register for processing. This design simplifies the architecture and instruction set, allowing for faster data manipulation since the accumulator can be quickly accessed. Additionally, many instructions involve loading data into the accumulator, performing operations, and then storing the results back, emphasizing its central role in the microprocessor's operation.
Accumulator is what the British call a capacitor.
The size of the accumulator is the same,means 64bit.
As a rule, you'll need to purchase an appropriate re-seal kit for your accumulator. You will then need to disassemble your accumulator, clean everything and reassemble the accumulator with the new seals that came in your kit.
You have what is called an accumulator and an expansion tube witch are filters.........
The accumulator stores brake fluid under very high pressure. An electric pump keeps the accumulator pressurized with brake fluid. When you press the brake pedal, pressurized fluid from the accumulator operates the brakes.
The main reasons that an accumulator is used in a hydraulic system are so that the pump doesn't need to be so large to cope with extremes of demand, so that the supply circuit can respond more quickly to any temporary demand and to smooth pulsations.
There is no set millage for when you should replace a manifold line and accumulator. Most mechanics only replace when the accumulator and/or manifold lineÊstart to fail.